Home › General › MAINTENANCE › FRONT DISC BRAKE PAD (for TMC Made) › from 2019.09
RM32H0E _V1 General _059503 MAINTENANCE _0407340 FRONT DISC BRAKE PAD(for TMC Made) A

MAINTENANCE  FRONT DISC BRAKE PAD(for TMC Made)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attention to the surroundings.

·

Immediately after installing the front disc brake pads, the brake pedal may feel soft due to clearance between the front disc brake pads and front disc. Depress the brake pedal several times until the brake pedal feels firm.



HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.REMOVE FRONT DISC BRAKE PAD

CAUTION:
·
C368018

After lifting up the front disc brake cylinder assembly, secure it in place before performing any work on it.

·

The front disc brake cylinder assembly could fall, pinching hands or fingers and causing injury.



a.
C421953C01
1.51,2.875 1.823,3.031 0.313,0.156 10 false *a 0.771,2.885 1.083,3.042 0.313,0.156 10 false *b
*a Turn
*b Hold


Hold the front disc brake cylinder slide pin (lower side) and remove the bolt.

NOTICE:

Do not kink or damage the brake line.



b.

Pull the front disc brake cylinder assembly upward.


c.
C421954

Remove the 2 front disc brake pads from the front disc brake cylinder mounting.


Hide 04945 3.REMOVE FRONT DISC BRAKE ANTI-SQUEAL SHIM KIT

a.

Remove the front No. 1 disc brake anti-squeal shim and front No. 2 disc brake anti-squeal shim from each front disc brake pad.


b.
C369832

Using a screwdriver, remove the front disc brake pad wear indicator plate from each front disc brake pad.