Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING SUPPORT BRAKE SYSTEM › from 2019.09
RM32H0E _56 Audio / Visual / Telematics _060571 PARK ASSIST / MONITORING _0407350 PARKING SUPPORT BRAKE SYSTEM U

PARK ASSIST / MONITORING  PARKING SUPPORT BRAKE SYSTEM  TERMINALS OF ECU  


CLEARANCE WARNING ECU ASSEMBLY


E220917E73
3.375,0.219 3.813,0.5 0.438,0.281 3.438,0.271 3.896,0.469 0.458,0.198 10 false F142

a.

Disconnect the F142 clearance warning ECU assembly connector.


b.

Measure the voltage and resistance on the wire harness side connector according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
F142-1 (IG) - F142-28 (E) BE - W-B IG engine source signal Ignition switch off Below 1 V
Ignition switch ON 11 to 14 V
F142-28 (E) - Body ground W-B - Body ground Ground Always Below 1 Ω


c.

Reconnect the F142 clearance warning ECU assembly connector.


d.

Measure the voltage and check for pulses according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
F142-2 (BOF) - F142-28 (E) GR - W-B Power source for front sensor circuit Ignition switch off Below 1 V
·

Ignition switch ON

·

Parking support brake system on


11 to 14 V
F142-4 (E5) - F142-28 (E) LG - W-B Ground for front clearance sonar Always Below 1 Ω
F142-3 (SOF) - F142-28 (E) SB - W-B Front sensor communication signal (Front clearance sonar sensor)
·

Ignition switch ON

·

Parking support brake system on

·

Shift lever in any position other than P or R

·

Vehicle speed is less than approximately 10 km/h (6 mph)


Pulse generation
(Refer to waveform 1)
F142-9 (CBZ) - F142-8 (EF) SB - P No. 1 clearance warning buzzer signal Buzzer sounding Pulse generation
(Refer to waveform 2)
F142-25 (BBZ) - F142-26 (ER) L - B No. 2 clearance warning buzzer signal Buzzer sounding Pulse generation
(Refer to waveform 2)
F142-19 (BOR) - F142-28 (E) LG - W-B Power source for rear sensor circuit Ignition switch off Below 1 V
·

Ignition switch ON

·

Parking support brake system on


11 to 14 V
F142-21 (E1) - F142-28 (E) P - W-B Ground for rear clearance sonar Always Below 1 Ω
F142-20 (SOR) - F142-28 (E) G - W-B Rear sensor communication signal (Rear clearance sonar sensor)
·

Ignition switch ON

·

Parking support brake system on

·

Shift lever in R

·

Vehicle speed is less than approximately 10 km/h (6 mph)


Pulse generation
(Refer to waveform 3)


e.

Using an oscilloscope, check waveform 1.

i.
E314893N08
0.177,0.99 0.635,1.188 0.458,0.198 10 false GND

Waveform 1 (Reference)

Item Content
Measurement terminal F142-3 (SOF) - F142-28 (E)
Measurement setting 5 V/DIV., 1 ms./DIV.
Condition
·

Ignition switch ON

·

Parking support brake system on

·

Shift lever in any position other than P or R

·

Vehicle speed is less than approximately 10 km/h (6 mph)





f.

Using an oscilloscope, check waveform 2.

i.
E227014N05
0.083,1.677 0.552,1.938 0.469,0.26 10 GND

Waveform 2 (Reference)

Item Content
Measurement terminal F142-9 (CBZ) - F142-8 (EF)
F142-25 (BBZ) - F142-26 (ER)
Measurement setting 2 V/DIV., 500 μs./DIV.
Condition Buzzer sounding

HINT:

The amplitude of the waveform changes according to the set volume.




g.

Using an oscilloscope, check waveform 3.

i.
E314893N08
0.177,0.99 0.635,1.188 0.458,0.198 10 false GND

Waveform 3 (Reference)

Item Content
Measurement terminal F142-20 (SOR) - F142-28 (E)
Measurement setting 5 V/DIV., 1 ms./DIV.
Condition
·

Ignition switch ON

·

Parking support brake system on

·

Shift lever in R

·

Vehicle speed is less than approximately 10 km/h (6 mph)