When any of the following parts have been replaced, perform adjustment shown in the following table. If not, the TOYOTA parking assist-sensor system may not operate correctly.
ADJUST TOYOTA PARKING ASSIST-SENSOR SYSTEM
w/ Parking Support Brake System
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during TOYOTA parking assist-sensor system removal/installation are shown below.
*: w/ Blind Spot Monitor System
w/o Parking Support Brake System
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during TOYOTA parking assist-sensor system removal/installation are shown below.
*: w/ Blind Spot Monitor System
REGISTRATION (PROCEDURE 1)
Preparation
Check for DTCs.
If DTC C1AE087, C1AE187, C1AE287, C1AE387, C1AE487, C1AE587, C1AE687, C1AE787, C1AE887, C1AE987, C1AF187, C1AF287 are output, continue with the registration procedure.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Clearance Warning / Utility.
| Tester Display |
|---|
| ECU Calibration |
According to the display on the GTS, perform calibration.
Enter the bumper type using the GTS.
| Bumper Type | Value |
|---|---|
| w/ Parking Support Brake System | 1 |
| w/o Parking Support Brake System | 2 |
If the clearance warning ECU assembly is replaced or removed and installed, it is necessary to perform bumper type registration.