CLEARANCE WARNING ECU ASSEMBLY
Disconnect the F142 clearance warning ECU assembly connector.
Measure the voltage and resistance on the wire harness side connector according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| F142-1 (IG) - F142-28 (E) | BE - W-B | IG power source signal | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V | |||
| F142-28 (E) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
Reconnect the F142 clearance warning ECU assembly connector.
Measure the voltage and check for pulses according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| F142-2 (BOF) - F142-28 (E) | GR - W-B | Power source for front sensor circuit | Ignition switch off | Below 1 V |
·
Ignition switch ON ·
TOYOTA parking assist-sensor system on |
11 to 14 V | |||
| F142-3 (SOF) - F142-28 (E) | SB - W-B | Front sensor communication signal (Front clearance sonar sensor) | ·
Ignition switch ON ·
TOYOTA parking assist-sensor system on ·
Shift lever in any position other than P or R ·
Vehicle speed is less than approximately 10 km/h (6 mph) |
Pulse generation
(Refer to waveform 1) |
| F142-4 (E5) - F142-28 (E) | LG - W-B | Ground for front clearance sonar | Always | Below 1 V |
| F142-5 (CSB1) - F142-28 (E) | R - W-B | Power source for front side sensor circuit | Ignition switch off | Below 1 V |
·
Ignition switch ON ·
TOYOTA parking assist-sensor system on |
11 to 14 V | |||
| F142-6 (LIN1) - F142-28 (E) | V - W-B | Front side sensor communication signal (Front side clearance sonar sensor) | ·
Ignition switch ON ·
TOYOTA parking assist-sensor system on ·
Shift lever in any position other than P ·
Vehicle speed is less than approximately 10 km/h (6 mph) |
Pulse generation
(Refer to waveform 3) |
| F142-7 (CSG1) - F142-28 (E) | G - W-B | Ground for front side clearance sonar | Always | Below 1 V |
| F142-8 (EF) - F142-28 (E) | P - W-B | Ground for clearance warning buzzer | Always | Below 1 V |
| F142-9 (CBZ) - F142-8 (EF) | SB - P | Clearance warning buzzer signal | Buzzer sounding | Pulse generation
(Refer to waveform 2) |
| F142-19 (BOR) - F142-28 (E) | Y - W-B | Power source for rear sensor circuit | Ignition switch off | Below 1 V |
·
Ignition switch ON ·
TOYOTA parking assist-sensor system on |
11 to 14 V | |||
| F142-20 (SOR) - F142-28 (E) | G - W-B | Rear sensor communication signal (Rear clearance sonar sensor) | ·
Ignition switch ON ·
TOYOTA parking assist-sensor system on ·
Shift lever in R ·
Vehicle speed is less than approximately 10 km/h (6 mph) |
Pulse generation
(Refer to waveform 1) |
| F142-21 (E1) - F142-28 (E) | P - W-B | Ground for rear clearance sonar | Always | Below 1 V |
| F142-22 (CSB2) - F142-28 (E) | L - W-B | Power source for rear side sensor circuit | Ignition switch off | Below 1 V |
·
Ignition switch ON ·
TOYOTA parking assist-sensor system on |
11 to 14 V | |||
| F142-23 (LIN2) - F142-28 (E) | LG - W-B | Rear side sensor communication signal (Rear side clearance sonar sensor) | ·
Ignition switch ON ·
TOYOTA parking assist-sensor system on ·
Shift lever in any position other than P ·
Vehicle speed is less than approximately 10 km/h (6 mph) |
Pulse generation
(Refer to waveform 3) |
| F142-24 (CSG2) - F142-28 (E) | R - W-B | Ground for rear side clearance sonar | Always | Below 1 V |
| F142-25 (BBZ) - F142-26 (ER) | L - B | Clearance warning buzzer signal | Buzzer sounding | Pulse generation
(Refer to waveform 2) |
| F142-26 (ER) - F142-28 (E) | B - W-B | Ground for clearance warning buzzer | Always | Below 1 V |
Using an oscilloscope, check waveform 1.
Waveform 1 (Reference)
| Item | Content |
|---|---|
| Measurement terminal | ·
CH1: F142-3 (SOF) - F142-28 (E) ·
CH2: F142-20 (SOR) - F142-28 (E) |
| Measurement setting | 5 V/DIV., 1 ms./DIV. |
| Condition | ·
Engine running ·
TOYOTA parking assist-sensor system on ·
Shift lever in any position other than P or R (CH1) ·
Shift lever in R (CH2) ·
Vehicle speed is less than approximately 10 km/h (6 mph) |
The waveforms for CH1 and CH2 are same.
Using an oscilloscope, check waveform 2.
Waveform 2 (Reference)
| Item | Content |
|---|---|
| Measurement terminal | F142-9 (CBZ) - F142-8 (EF)
F142-25 (BBZ) - F142-26 (ER) |
| Measurement setting | 2 V/DIV., 500 μs./DIV. |
| Condition | Buzzer sounding |
The amplitude of the waveform changes according to the set volume.
Using an oscilloscope, check waveform 3.
Waveform 3 (Reference)
| Item | Content |
|---|---|
| Measurement terminal | ·
F142-6 (LIN1) - F142-28 (E) ·
F142-23 (LIN2) - F142-28 (E) |
| Measurement setting | 5 V/DIV., 1 ms./DIV. |
| Condition | ·
Ignition switch ON ·
TOYOTA parking assist-sensor system on ·
Shift lever in any position other than P ·
Vehicle speed is less than approximately 10 km/h (6 mph) |
BLIND SPOT MONITOR SENSOR RH (A) (w/ Blind Spot Monitor System)
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>TERMINALS OF ECU
BLIND SPOT MONITOR SENSOR LH (B) (w/ Blind Spot Monitor System)
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>TERMINALS OF ECU