FREEZE FRAME DATA
Whenever an automatic headlight beam level control system DTC is stored, the headlight ECU sub-assembly LH stores the current vehicle state as freeze frame data.
CHECK FREEZE FRAME DATA
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / AFS / Trouble Codes.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>DTC CHECK / CLEAR
Select a DTC to display its freeze frame data.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Traveling Direction | Traveling direction | Not Fwd or Fwd | Not Fwd: Shift lever in R or N
Fwd: Shift lever not in R or N |
- |
| Headlight Low Beam State | Low beam headlight state | OFF or ON | OFF: Low beam headlight off
ON: Low beam headlight on |
- |
| Headlight High Beam State | High beam headlight state | OFF or ON | OFF: High beam headlight off
ON: High beam headlight on |
- |
| DRL State | Daytime running light state | OFF or ON | OFF: Daytime running light off
ON: Daytime running light on |
- |
| Clearance Light State | Parking light state | OFF or ON | OFF: Parking light off
ON: Parking light on |
- |
| Engine | Engine condition | Stop or Run | Stop: Engine is stopped
Run: Engine is running |
- |
| Steering Sens Signal | Steering sensor signal value | -384.0 to 382.5 deg | Changes according to the operation of the steering wheel | Turning left: Increases
Turning right: Decreases |
| FR Wheel Speed | Front right wheel speed | 0.00 to 260.00 km/h (162.00 mph) | Condition can be displayed | - |
| FL Wheel Speed | Front left wheel speed | 0.00 to 260.00 km/h (162.00 mph) | Condition can be displayed | - |
| Vehicle Acceleration | Vehicle acceleration | -445.64 to 445.63 m/s2 | Condition can be displayed | - |
| Leveling Motor Slave | Status of the headlight swivel and leveling motor slave | Normal or Abnoml | Normal: Headlight swivel and leveling motor is normal
Abnoml: Headlight swivel and leveling motor is not normal |
If operation is abnormal, there may be a LIN communication error |
| Leveling Motor Over-Run | Status of the headlight swivel and leveling motor over-run | Normal or Abnoml | Normal: Headlight swivel and leveling motor is normal
Abnoml: Headlight swivel and leveling motor is not normal |
If operation is abnormal, there may be a LIN communication error |
| +B | Headlight ECU sub-assembly LH IG power supply voltage value | 0.00 to 19.75 V | 11.00 to 14.00 V | - |
| +B Voltage Value | Number of trouble codes | 0.00 to 19.75 V | 11.00 to 14.00 V | - |
| Number Of Trouble Codes | Number of trouble codes | 0 to 255 | Number of stored DTCs displayed | - |
CLEAR FREEZE FRAME DATA
Clearing the DTCs will also clear the freeze frame data.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Clear the DTCs and freeze frame data.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>DTC CHECK / CLEAR