Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › SIMPLE INTELLIGENT PARKING ASSIST SYSTEM › from 2019.09
RM32H0E _56 Audio / Visual / Telematics _060571 PARK ASSIST / MONITORING _0300931 SIMPLE INTELLIGENT PARKING ASSIST SYSTEM W

PARK ASSIST / MONITORING  SIMPLE INTELLIGENT PARKING ASSIST SYSTEM  CUSTOMIZE PARAMETERS  


CUSTOMIZE SIMPLE INTELLIGENT PARKING ASSIST SYSTEM


a.

Customizing with the GTS.

NOTICE:
·

When the customer requests a change in a function, first make sure that the function can be customized.

·

Be sure to make a note of the current settings before customizing.

·

When troubleshooting a function, first make sure that the function is set to the default setting.



i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the TOYOTA parking assist-sensor system on.


iv.

Turn the GTS on.


v.

Enter the following menus: Body Electrical / Clearance Warning / Utility / Customize Setting.


vi.

Select the setting by referring to the table below.

Clearance Warning
Tester Display Description Default Setting ECU
Ultrasonic Sensor (Side) Alarm Function Sets the operation range for the side sensors. ON $00:OFF,$01:ON Clearance warning ECU assembly
Ultrasonic Sensor (Side) Alarm Detection Range Sets the detection operation range for the side sensors. Far $00:Close,$01:Far Clearance warning ECU assembly
IPA Obstacle Avoidance Distance Simple intelligent parking assist obstacle avoidance distance setting Normal $00:Narrow,$01:Normal,$02:Wide1,$03:Wide2 Clearance warning ECU assembly
IPA Perpendicular Parking Control Area Simple intelligent parking assist perpendicular parking range setting Normal $00:Narrow,$01:Normal,$02:Wide1,$03:Wide2 Clearance warning ECU assembly
IPA Parallel Parking Control Area Simple intelligent parking assist parallel parking range setting Normal $00:Narrow,$01:Normal,$02:Wide1,$03:Wide2 Clearance warning ECU assembly
50006 101