Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › SIMPLE INTELLIGENT PARKING ASSIST SYSTEM › from 2019.09
RM32H0E _56 Audio / Visual / Telematics _060571 PARK ASSIST / MONITORING _0300931 SIMPLE INTELLIGENT PARKING ASSIST SYSTEM U

PARK ASSIST / MONITORING  SIMPLE INTELLIGENT PARKING ASSIST SYSTEM  TERMINALS OF ECU  


CLEARANCE WARNING ECU ASSEMBLY


E220917E70
3.5,0.104 3.896,0.344 0.396,0.24 3.552,0.146 4.063,0.458 0.51,0.313 10 false F142

a.

Disconnect the F142 clearance warning ECU assembly connector.


b.

Measure the voltage and resistance on the wire harness side connector according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
F142-1 (IG) - F142-28 (E) BE - W-B IG power source signal Ignition switch off Below 1 V
Ignition switch ON 11 to 14 V
F142-28 (E) - Body ground W-B - Body ground Ground Always Below 1 Ω

If the result is not as specified, there may be a malfunction in the wire harness.


c.

Reconnect the F142 clearance warning ECU assembly connector.


d.

Measure the voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
F142-13 (ISSW) - F142-28 (E) V - W-B IPA main switch assembly signal Ignition switch ON, IPA main switch assembly pressed Below 1 V
Ignition switch ON, IPA main switch assembly switch not pressed 9.5 to 14 V

If the result is not as specified, the clearance warning ECU assembly may be malfunctioning.