The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the windshield wiper relay assembly removal/installation are shown below.
After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) battery terminal (for Audio and Visual System).
After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) battery terminal (for Navigation System (for Radio and Display Type)).
55401E
1.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
85940
2.REMOVE WINDSHIELD WIPER RELAY ASSEMBLY
Disconnect the connector.
Remove the bolt.
Disengage the guide to remove the windshield wiper relay assembly.