Home › Drivetrain › K313F (MULTIDRIVE / CVT) › OIL PAN › from 2019.09
RM32H0E _52 Drivetrain _059618 K313F MULTIDRIVE / CVT _0292478 OIL PAN A

K313F MULTIDRIVE / CVT  OIL PAN  INSTALLATION  


PROCEDURE

Hide 1.INSTALL OIL STRAINER ASSEMBLY

HINT:

Perform this procedure only when replacement of the oil strainer assembly is necessary.


a.

Coat a new O-ring with Toyota Genuine CVT fluid FE and install it to the oil strainer assembly.

NOTICE:

Ensure that the O-ring is not twisted.



b.
C305428N01
1.031,0.302 1.188,0.5 0.156,0.198 10 true A 2.76,0.969 2.917,1.167 0.156,0.198 10 true A 1.896,1.938 2.052,2.135 0.156,0.198 10 true B

Install the oil strainer assembly to the transmission valve body assembly with the 3 bolts.

Torque:
10.8 N*m (110 kgf*cm, 8 ft.*lbf)

NOTICE:
·

Make sure that the transmission wire is not pinched.

·

Be careful not to damage the O-ring.



HINT:
Bolt Length
·

Bolt (A): 16 mm (0.630 in.)

·

Bolt (B): 25 mm (0.984 in.)




Hide 35394D 2.INSTALL OIL CLEANER (CVT) MAGNET

a.
C326863C01
0.438,1.125 1.979,0.854 true 2.177,1.479 0.427,1.125 0.427,1.125 1.146,0.781 true 0.26,1.052 0.573,1.208 0.313,0.156 10 false *1
*1 Oil Cleaner (CVT) Magnet


Install the 3 oil cleaner (CVT) magnets to the transaxle oil (CVT) pan sub-assembly as shown in the illustration.


Hide 35106L 3.INSTALL TRANSAXLE OIL (CVT) PAN SUB-ASSEMBLY

a.

Clean the transaxle oil (CVT) pan sub-assembly installation surface of the transaxle case.


b.

Install the transaxle oil (CVT) pan sub-assembly and a new transaxle oil pan (CVT) gasket to the transaxle case with the 16 bolts.

Torque:
7.8 N*m (80 kgf*cm, 69 in.*lbf)


c.

Using a 6 mm hexagon socket wrench, install the No. 1 transmission oil filler tube to the transaxle oil (CVT) pan sub-assembly.

Torque:
1.7 N*m (17 kgf*cm, 15 in.*lbf)


d.

Using a 6 mm hexagon socket wrench, temporarily install the overflow plug and gasket to the transaxle oil (CVT) pan sub-assembly.

HINT:

Reuse the old gasket as the overflow plug will be removed again to adjust the fluid level.



Hide 4.ADD CONTINUOUSLY VARIABLE TRANSAXLE FLUID

Hide 5.INSPECT FOR CONTINUOUSLY VARIABLE TRANSAXLE FLUID LEAK

Hide 51444A 6.INSTALL REAR ENGINE UNDER COVER LH

Hide 51441 7.INSTALL NO. 1 ENGINE UNDER COVER