The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the driving support buzzer (pre-collision city buzzer) removal/installation are shown below.
55545
1.REMOVE FUSE BOX OPENING COVER
86652E
2.REMOVE DRIVING SUPPORT BUZZER (PRE-COLLISION CITY BUZZER)
Disengage the clamp.
Disconnect the connector to remove the driving support buzzer (pre-collision city buzzer).
If the driving support buzzer (pre-collision city buzzer) has been struck or dropped, replace it with a new one.