This DTC is stored when a key is inserted into the ignition key cylinder but no communication occurs between the key and transponder key ECU assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B2796 | No Communication in Immobiliser System | The key ID code cannot be transmitted to the transponder key ECU assembly (1 trip detection logic*). | ·
Key ·
Wire harness or connector ·
Transponder key coil ·
Transponder key ECU assembly |
DTC Output Confirmation Operation:
Insert the key into the ignition key cylinder. |
*: Only output while a malfunction is present.
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
| Engine cannot be started | - |
| DTC No. | Data List and Active Test |
|---|---|
| B2796 | - |
If the transponder key ECU assembly or key is replaced, refer to Service Bulletin.
After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Insert and remove each registered key one at a time, and check for DTCs each time.
Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.
B2796 is not output.
| Result | Proceed to |
|---|---|
| B2796 is not output | A |
| DTC B2796 is output for all of the keys | B |
| DTC B2796 is output for any of the keys | C |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C
Replace the transponder key ECU assembly with a new one.
Refer to Service Bulletin.
Key ID code registration is necessary when replacing the transponder key ECU assembly.
Refer to Service Bulletin.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.
DTC B2796 is not output.
| Result | Proceed to |
|---|---|
| B2796 is not output | A |
| B2796 is output | B |
A
B
Replace the key for which the DTC was stored.
Key ID code registration is necessary when replacing the key.
Refer to Service Bulletin.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.
DTC B2796 is not output.
| Result | Proceed to |
|---|---|
| B2796 is not output | A |
| B2796 is output | B |
A
B