The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during parking assist ECU removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Use the same procedure for LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
1.REMOVE FRONT SEAT ASSEMBLY RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>REMOVAL
86796
2.REMOVE PARKING ASSIST ECU COVER
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Disengage the clips and guide to remove the parking assist ECU cover as shown in the illustration.
86792C
3.REMOVE PARKING ASSIST ECU
Disconnect the connector.
Turn back the part of the front floor carpet assembly.
Remove the 2 bolts and parking assist ECU.