The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the driving support buzzer (pre-collision city buzzer) removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
55545
1.REMOVE FUSE BOX OPENING COVER
86652E
2.REMOVE DRIVING SUPPORT BUZZER (PRE-COLLISION CITY BUZZER)
Disengage the clamp.
Disconnect the connector to remove the driving support buzzer (pre-collision city buzzer).
If the driving support buzzer (pre-collision city buzzer) has been struck or dropped, replace it with a new one.