CHECK DTC
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Cruise Control*1 or Radar Cruise 2*2 / Trouble Codes.
Cruise Control: Stored in the ECM
Radar Cruise2: Stored in millimeter wave radar sensor assembly
Check for DTCs (Test Failed / Pending / Confirmed).
| GTS Display | Description |
|---|---|
| Test Failed | Represent malfunctions that were detected during the current trip. |
| Pending | Represent malfunctions which have occurred since the DTCs were last cleared but have not been confirmed. |
| Confirmed | Represent malfunctions which have occurred since the DTCs were last cleared and have been confirmed. (The number of trips since the DTC was stored may differ for each DTC.) |
Freeze frame data is stored respectively for pending DTCs, confirmed DTCs and the latest DTCs.
CLEAR DTC
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Cruise Control*1 or Radar Cruise 2*2 / Clear DTCs.
Cruise Control: Stored in the ECM
Radar Cruise2: Stored in millimeter wave radar sensor assembly
Clear the DTCs.
Clearing the DTCs will also clear the freeze frame data.