When a malfunction is detected between various ECUs and sensors, these DTCs are stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U010087 | Lost Communication With ECM/PCM "A" Missing Message | When the ignition switch is ON for 3 seconds or more, and the vehicle is being driven at a speed of 5 km/h (3 mph) or more, a communication malfunction between the forward recognition camera and the ECM continues for 2 seconds or more. | CAN communication system |
| U010187 | Lost Communication with TCM Missing Message | When the ignition switch is ON for 3 seconds or more, a communication malfunction between the forward recognition camera and the ECM continues for approximately 5 seconds or more. | CAN communication system |
| U012687 | Lost Communication with Steering Angle Sensor Module Missing Message | When the ignition switch is ON for 3 seconds or more, a communication malfunction between the forward recognition camera and the steering sensor continues for approximately 1 second or more. | CAN communication system |
| U012987 | Lost Communication with Brake System Control Module Missing Message | When the ignition switch is ON for 3 seconds or more, a communication malfunction between the forward recognition camera and the skid control ECU (brake actuator assembly) continues for approximately 1 second or more. | CAN communication system |
| U014087 | Lost Communication with Body Control Module Missing Message | When the ignition switch is ON for 3 seconds or more, a communication malfunction between the forward recognition camera and the main body ECU (multiplex network body ECU) continues for 5 seconds or more. | CAN communication system |
| U015587 | Lost Communication with Instrument Panel Cluster (IPC) Control Module Missing Message | When the ignition switch is ON for 3 seconds or more, a communication malfunction between the forward recognition camera and the combination meter assembly continues for 5 seconds or more. | CAN communication system |
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC U010087, U010187, U012687, U012987, U014087 and U015587 are not output | A |
| DTC U010087, U010187, U012687, U012987, U014087 or U015587 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING