Home › Engine / Hybrid System › CRUISE CONTROL › LANE TRACING ASSIST SYSTEM › from 2020.08
RM32H0E _51 Engine / Hybrid System _059516 CRUISE CONTROL _0441734 LANE TRACING ASSIST SYSTEM U

CRUISE CONTROL  LANE TRACING ASSIST SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


NOTICE:

Some Data List values may vary significantly due to slight measurement errors, differences in the measurement environment, and changes in the vehicle over time, making it difficult to indicate clear evaluation standards. It is possible that a malfunction may be present even if measured values are within the reference range.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Chassis / Lane Control / Data List.


e.

According to the display on the GTS, read the Data List.

Chassis > Lane Control > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Total Distance Traveled - - - Cannot be used
Total Distance Traveled - Unit - - - Cannot be used
LDA Control Lane tracing assist system control status Prohibit or Permit Prohibit: Lane tracing assist system control not possible
Permit: Lane tracing assist system control possible
-
Turn Switch (Right) Right turn signal switch status OFF or ON ON: Turn signal switch on (right)
OFF: Turn signal switch off (right)
-
Turn Switch (Left) Left turn signal switch status OFF or ON ON: Turn signal switch on (left)
OFF: Turn signal switch off (left)
-
Vehicle Information (2WD/4WD) - - - Cannot be used
Vehicle Information (Powertrain Type) - - - Cannot be used


ACTIVE TEST


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Chassis / Lane Control / Active Test.


e.

According to the display on the GTS, perform the Active Test.

Chassis > Lane Control > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Steering Wheel Vibration - - Cannot be used
Meter Buzzer Sounds the meter buzzer Start or Stop Confirm that the vehicle is stopped with the ignition switch ON.

f.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


g.

According to the display on the GTS, perform the Active Test.

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Meter Display 1 Multi-information display OFF, 6 to 0 or All -