Home › Engine / Hybrid System › 8NR-FTS (LUBRICATION) › OIL PUMP › from 2020.08
RM32H0E _51 Engine / Hybrid System _060037 8NR-FTS LUBRICATION _0294100 OIL PUMP A

8NR-FTS LUBRICATION  OIL PUMP  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the oil pump assembly removal/ installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Panoramic view monitor system (Click here)
Replacement of CVT fluid ATF thermal degradation estimate reset The value of the Data List item "ATF thermal Degradation Estimate" is not estimated correctly for K313
(Click here)
for K313F
(Click here)
Front wheel alignment adjustment Perform the following procedures in the order shown:
1.

Clear zero point calibration data and store system information

2.

Perform yaw rate and acceleration sensor zero point calibration and store system information


·

VSC disabled or malfunctions

·

DTCs are stored

·

Slip indicator light illuminates

·

ABS warning light illuminates


(Click here)

HINT:

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: When performing learning using the GTS

Click here(Click here)

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Simple intelligent parking assist system*1
Parking support brake system*1

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 13506 1.REMOVE CHAIN SUB-ASSEMBLY

Hide 13521 2.REMOVE CRANKSHAFT TIMING SPROCKET

Hide 13507 3.REMOVE NO. 2 CHAIN SUB-ASSEMBLY

Hide 12102A 4.REMOVE NO. 2 OIL PAN SUB-ASSEMBLY

Hide 15100 5.REMOVE OIL PUMP ASSEMBLY

a.
A353070

Remove the 3 bolts and oil pump assembly from the stiffening crankcase assembly.