Home › Power Source / Network › 8NR-FTS (BATTERY / CHARGING) › BATTERY CURRENT SENSOR › from 2020.08
RM32H0E _57 Power Source / Network _060209 8NR-FTS BATTERY / CHARGING _0295246 BATTERY CURRENT SENSOR A

8NR-FTS BATTERY / CHARGING  BATTERY CURRENT SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the battery removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Panoramic view monitor system (Click here)

HINT:

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: When performing learning using the GTS

Click here(Click here)

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Simple intelligent parking assist system*1
Parking support brake system*1

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 28850C 2.REMOVE BATTERY STATE SENSOR ASSEMBLY

a.
A392494

Remove the nut to disconnect the engine wire from the battery state sensor assembly.


b.
A392495

Loosen the nut and disconnect the battery state sensor assembly from the battery.


c.
A392496

Disconnect the battery state sensor assembly connector.


d.

Disengage the clamp and disconnect the engine wire from the battery state sensor assembly.


e.
A392497

Disengage the 2 claws and remove the battery state sensor assembly from the battery current sensor holder.