Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP (for 8NR-FTS) › from 2020.08
RM32H0E _54 Brake _060040 BRAKE SYSTEM (OTHER) _0299736 VACUUM PUMP(for 8NR-FTS) A

BRAKE SYSTEM (OTHER)  VACUUM PUMP(for 8NR-FTS)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the vacuum pump assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Panoramic view monitor system (Click here)

CAUTION / NOTICE / HINT

HINT:

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: When performing learning using the GTS

(Click here)

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Simple intelligent parking assist system*1
Parking support brake system*1

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 28800 1.REMOVE BATTERY

Hide 2.DISCONNECT UNION TO CONNECTOR TUBE HOSE

a.
C366917

Slide the clip and disconnect the union to connector tube hose from the vacuum pump assembly.


Hide 29300 3.REMOVE VACUUM PUMP ASSEMBLY

a.
C366918

Disconnect the No. 1 vacuum transmitting hose assembly from the vacuum pump assembly.


b.
C366919

Remove the 3 bolts and vacuum pump assembly from the engine assembly.


c.
C326537C02
1.698,1.167 2.094,0.406 2.094,0.406 2.427,0.406 true 0.823,2.021 1.125,2.021 1.125,2.021 1.125,1.781 true 2.469,0.344 2.781,0.5 0.313,0.156 10 false *1 0.656,1.958 0.969,2.115 0.313,0.156 10 false *2
*1 No. 2 O-ring
*2 No. 3 O-ring


Remove the No. 2 O-ring and No. 3 O-ring from the vacuum pump assembly.