Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM WARNING SWITCH (for LHD) › from 2020.08
RM32H0E _54 Brake _060040 BRAKE SYSTEM (OTHER) _0298583 VACUUM WARNING SWITCH(for LHD) A

BRAKE SYSTEM (OTHER)  VACUUM WARNING SWITCH(for LHD)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during vacuum warning switch assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Panoramic view monitor system (Click here)

CAUTION / NOTICE / HINT

HINT:

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: When performing learning using the GTS

(Click here)

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Simple intelligent parking assist system*1
Parking support brake system*1

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

Hide 55737B 2.REMOVE NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL

Hide 55736D 3.REMOVE COWL BODY MOUNTING REINFORCEMENT LH

Hide 55735C 4.REMOVE COWL BODY MOUNTING REINFORCEMENT RH

Hide 55701J 5.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY

Hide 28800 6.REMOVE BATTERY

Hide 83390H 7.REMOVE VACUUM WARNING SWITCH ASSEMBLY

a.
C366941

Disconnect the connector from the vacuum warning switch assembly.


b.

Remove the vacuum warning switch assembly from the brake booster assembly.


c.

Remove the check valve grommet from the brake booster assembly.