Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM › from 2020.08
RM32H0E _58 Vehicle Interior _059622 PRE-COLLISION _0298842 PRE-COLLISION SYSTEM D

PRE-COLLISION  PRE-COLLISION SYSTEM  CUSTOMIZE PARAMETERS  


CUSTOMIZE PRE-COLLISION SYSTEM


NOTICE:
·

When the customer requests a change in a function, first make sure that the function can be customized.

·

Make a note of the current settings before customizing.



a.

Customizing with the Multi-information Display

HINT:

The following PCS functions and the pre-collision system sensitivity setting can be changed from their default setting.


i.

Turn the ignition switch to ON.


ii.

Change pre-collision system settings by operating steering pad switch.

HINT:

Pre-collision system settings are shown in the Settings tab of the multi-information display.


Pre-collision System Settings
Display Description Setting Default
PCS Turns the pre-collision system function ON/OFF. ON/OFF ON
Sensitivity Sets the pre-collision system function warning sensitivity Early/Mid/Late Mid



b.

Customizing with the GTS

HINT:

The following customization settings allow retention of applicable operation settings for the PCS operation state and PCS warning sensitivity distance to be turned ON or OFF.


i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the GTS on.


iv.

Enter the following menus: Customize Setting / Others.


v.

Select the setting by referring to the table below.

Others
Tester Display Description Default Setting ECU
PCS Function ON/OFF State Stored Refer to the table below Not Stored $00:Not Stored,$01:Stored Millimeter wave radar sensor assembly
PCS Warning Timing State Stored 1 Refer to the table below Not Stored $00:Not Stored,$01:Stored Millimeter wave radar sensor assembly
PCS Warning Timing State Stored 2 Refer to the table below Stored $00:Not Stored,$01:Stored Millimeter wave radar sensor assembly
PCS Warning Timing State Stored 3 Refer to the table below Not Stored $00:Not Stored,$01:Stored Millimeter wave radar sensor assembly
50006 98
Customize Setting Description Setting
PCS Function ON/OFF State Stored When the PCS function is OFF and the ignition switch is turned to off and then ON, this setting controls whether the prior PCS ON/OFF setting is retained. Not Stored: PCS function resets to ON
Stored: PCS function remains OFF
PCS Warning Timing State Stored 1 When the ignition switch is ON and the PCS function is turned from off to ON, this setting controls whether the prior PCS warning sensitivity setting is retained. Stored: Warning sensitivity is maintained at the previous value
Not Stored: Warning sensitivity resets to "Mid"
PCS Warning Timing State Stored 2 When the PCS function is ON and the ignition switch is turned to off and then ON, this setting controls whether the prior PCS warning sensitivity setting is retained. Stored: Warning sensitivity is maintained at the previous value
Not Stored: Warning sensitivity resets to "Mid"
PCS Warning Timing State Stored 3 When the PCS function is OFF and the ignition switch is turned to off and then ON, this setting controls whether the prior PCS warning sensitivity setting is retained. Stored: Warning sensitivity is maintained at the previous value
Not Stored: Warning sensitivity resets to "Mid"