Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM › from 2020.08
RM32H0E _58 Vehicle Interior _059622 PRE-COLLISION _0298842 PRE-COLLISION SYSTEM D

PRE-COLLISION  PRE-COLLISION SYSTEM  DIAGNOSIS SYSTEM  


FUNCTION OF WARNING INDICATOR AND MESSAGE


a.

If the pre-collision system is not functioning properly, the driver is warned by the PCS warning light and a warning message is displayed on the multi-information display.

Warning Message Detail DTC/RoB PCS warning light
"Pre-Collision System Malfunction Visit Your Dealer" Pre-collision system malfunctioning Stored Illuminates
"Pre-Collision System Radar In Self Calibration Unavailable See Owner's Manual" Millimeter wave radar sensor assembly misaligned Stored Illuminates
"Pre-Collision System Out of Temperature Range Unavailable See Owner's Manual" Millimeter wave radar sensor assembly temperature malfunction Stored Illuminates
"Pre-Collision System Unavailable See Owner's Manual"
·

Millimeter wave radar sensor assembly voltage malfunction

·

Determination was made for temporary suspension of system operation due to millimeter wave radar sensor assembly detecting interference from other nearby radar emitters


Stored Illuminates
"Pre-Collision System Radar Sensor Blocked Unavailable Clean Radar Sensor" Foreign matter attached to millimeter wave radar sensor assembly Stored Illuminates
"Front Camera Unavailable See Owner's Manual" Abnormal forward recognition camera voltage Stored Illuminates
"Front Camera Out of Temperature Range Unavailable Wait until Normal Temperature" Forward recognition camera temperature outside of operational range Stored Illuminates
"Front Camera Low Visibility Unavailable See Owner's Manual"
·

Foreign matter attached to forward recognition camera or area of windshield in front of forward recognition camera

·

Forward recognition camera or area of windshield in front of forward recognition camera is fogged up


Stored Illuminates
"VSC Turned Off Pre-Collision Brake System Unavailable" VSC system is disabled Not stored Illuminates

HINT:
PCS Warning Light Illumination Status
PCS Warning Light Condition
Illuminates Pre-collision system malfunctioning
Pre-collision system temporarily disabled
During pre-collision system radar alignment
Pre-collision system disabled
VSC system disabled
Not illuminated Other




INITIAL CHECK


a.

An initial check is performed when the ignition switch is off for more than 2 seconds and then turned ON. The initial check consists of a pre-collision system diagnostic check with a duration of approximately 3 seconds.


b.

If a malfunction is discovered during initial check, then after the initial check (after 3 seconds have elapsed), the PCS warning light in the combination meter assembly will illuminate and a message indicating a pre-collision system malfunction or that the pre-collision system is temporarily unusable will be displayed in the multi-information display.



CONSTANT CHECK


a.

The millimeter wave radar sensor assembly constantly monitors the pre-collision system for malfunctions after the ignition switch is turned ON and the initial check (approximately 3 seconds) has completed.


b.

If a malfunction is detected during the constant check, the PCS warning light in the combination meter assembly will illuminate and a warning message indicating the pre-collision system is malfunctioning or disabled will be displayed on the multi-information display.