Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM › from 2020.08
RM32H0E _58 Vehicle Interior _059622 PRE-COLLISION _0298842 PRE-COLLISION SYSTEM C

PRE-COLLISION  PRE-COLLISION SYSTEM  C142571  Stop Light Relay Actuator Stuck  


DESCRIPTION

The stop light switch and skid control ECU (brake actuator assembly) output stop light signals. If the skid control ECU (brake actuator assembly) detects a malfunction in circuits related to the stop light, it informs the millimeter wave radar sensor assembly via CAN communication, and DTC C142571 is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
C142571 Stop Light Relay Actuator Stuck When the ignition switch is ON for 3 seconds or more, a stop light circuit malfunction signal is received from the skid control ECU (brake actuator assembly) for 1 second or more. Vehicle stability control system

PROCEDURE

1.INSPECT VEHICLE STABILITY CONTROL SYSTEM
HINT:

If DTC C142571 is output by the pre-collision system, perform troubleshooting for the vehicle stability control system.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING


Result:
Proceed to
NEXT



NEXT

END