Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM › from 2020.08
RM32H0E _58 Vehicle Interior _059622 PRE-COLLISION _0298842 PRE-COLLISION SYSTEM C

PRE-COLLISION  PRE-COLLISION SYSTEM  U010087  Lost Communication with ECM/PCM "A" Missing Message  U012587  Lost Communication with Multi-axis Acceleration Sensor Module Missing Message  U012687  Lost Communication with Steering Angle Sensor Module Missing Message  U012987  Lost Communication with Brake System Control Module Missing Message  U015587  Lost Communication with Instrument Panel Cluster (IPC) Control Module Missing Message  


DESCRIPTION

The following DTCs are stored when there is a communication malfunction between the millimeter wave radar sensor and each sensor or ECU.

DTC No. Detection Item DTC Detection Condition Trouble Area
U010087 Lost Communication with ECM/PCM "A" Missing Message When the ignition switch is ON for 3 seconds or more, an ECM communication malfunction continues for approximately 3 seconds or more. CAN communication system
U012587 Lost Communication with Multi-axis Acceleration Sensor Module Missing Message When the ignition switch is ON for 3 seconds or more, at a vehicle speed of 5 km/h (3 mph) or more, a communication malfunction with the yaw rate sensor (airbag sensor assembly) continues for approximately 1 second or more. CAN communication system
U012687 Lost Communication with Steering Angle Sensor Module Missing Message When the ignition switch is ON for 3 seconds or more, a steering sensor communication malfunction continues for approximately 1 second or more. CAN communication system
U012987 Lost Communication with Brake System Control Module Missing Message When the ignition switch is ON for 3 seconds or more, a communication error between the skid control ECU (brake actuator assembly) and the millimeter wave radar sensor assembly is detected for approximately 1 second or more. CAN communication system
U015587 Lost Communication with Instrument Panel Cluster (IPC) Control Module Missing Message When the ignition switch is ON for 3 seconds or more, a combination meter assembly communication malfunction continues for 8 seconds or more. CAN communication system

PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Body Electrical > Pre-Collision System > Clear DTCs
50002 432

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTCs
2.CHECK FOR DTCs
a.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.



b.

Check for DTCs.

Body Electrical > Pre-Collision System > Trouble Codes
50001 432

Result:
Result Proceed to
DTC U010087, U012587, U012687, U012987 and U015587 are not output A
DTC U010087, U012587, U012687, U012987 or U015587 is output B



A

B