Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM › from 2020.08
RM32H0E _58 Vehicle Interior _060784 THEFT DETERRENT / KEYLESS ENTRY _0299016 THEFT DETERRENT SYSTEM D

THEFT DETERRENT / KEYLESS ENTRY  THEFT DETERRENT SYSTEM  SYSTEM DESCRIPTION  


OUTLINE OF THEFT DETERRENT SYSTEM


·

The theft deterrent system can be set by locking the doors using any of the following operations:

-

Entry lock operation*1

-

Wireless lock operation


*1: w/ Entry and Start System


·

In the armed state, the alarm function will be activated if one of the following conditions is met:

-

Any of the doors is unlocked.

-

Any of the doors or the engine hood is opened.


·

In the alarm sounding state, the system blinks the turn signal lights. At the same time, the system sounds the vehicle horns and security horn assembly to deter break-in and theft as well as to warn people around the vehicle.

·

The theft deterrent system can be canceled by unlocking the doors using any of the following operations:

-

Entry lock operation*1

-

Wireless lock operation

-

Key linked lock operation*2


*1: w/ Entry and Start System

*2: This function is set through the customize function.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>THEFT DETERRENT SYSTEM>CUSTOMIZE PARAMETERS


·

The theft deterrent system has an active arming mode. There are 4 states in this mode; a disarmed state, an arming preparation state, an armed state and an alarm sounding state.


a.

Disarmed state:

·

The alarm function is not operating.

·

The theft deterrent system is not operating.



b.

Arming preparation state:

·

The time until the system goes into the armed state.

·

The theft deterrent system is not operating.



c.

Armed state:

·

The theft deterrent system is operating.



d.

Alarm sounding state:

·

The alarm function is operating.


Alarm time:

Approximately 27.5 seconds


Alarm Methods
Alarm Method Turn Signal Lights Blinking
Vehicle Horns Sounding
(Approximately 0.4-second cycles)
Security Horn Assembly Sounding
(Approximately 0.4-second cycles)



FUNCTION OF MAIN COMPONENTS


Component Function
Security indicator light Informs driver of theft deterrent system status.
Security horn assembly Sounds when attempted break-in or theft is detected.
Turn signal lights Blink when attempted break-in or theft is detected.
Vehicle horns Sound when attempted break-in or theft is detected.
·

Front door courtesy light switch assembly (for LH/RH)

·

Rear door courtesy light switch assembly (for LH/RH)

·

Back door courtesy light switch


Detects door status (open or closed).
Door unlock detection switch Detects door status (locked or unlocked).
Hood courtesy switch (Hood lock assembly) Detects hood status (open or closed).
Certification ECU (Smart key ECU assembly)*1
·

Receives wireless door lock/unlock signal.

·

Receives entry door lock/unlock signal.


Main body ECU (multiplex network body ECU)*2 Receives wireless door lock/unlock signal.

*1: w/ Entry and Start System

*2: w/o Entry and Start System



ACTIVE ARMING MODE


a.

Active arming mode:

This system operates as described in the diagram below when one of the items for each condition is met.

HINT:

The term "all doors" used in this section refers to the driver door, front passenger door, rear door LH, rear door RH and back door.


B214494E24
1.688,1.521 3.146,1.76 1.458,0.24 10 Disarmed State (1)*1 2.302,3.188 4.021,3.396 1.719,0.208 10 Arming Preparation State 2.729,4.583 3.573,4.729 0.844,0.146 10 Armed State 2.406,5.99 3.99,6.24 1.583,0.25 10 Alarm Sounding State 0.24,6.979 3.438,7.198 3.198,0.219 10 *1: Disarmed state 1 is the normal disarmed state 0.24,7.313 5.792,7.583 5.552,0.271 10 *2: Disarmed state 2 is set from either the disarmed state 1 or arming preparation state 1.052,2.531 1.927,2.781 0.875,0.25 10 Condition [3] 3.771,4 4.719,4.26 0.948,0.26 10 Condition [2] 2.948,2.531 3.906,2.781 0.958,0.25 10 Condition [1] 3.833,5.365 4.823,5.677 0.99,0.313 10 Condition [4] 2.469,5.365 3.375,5.635 0.906,0.271 10 Condition [6] 0.563,4.469 1.448,4.708 0.885,0.24 10 Condition [5] 0.563,5.865 1.469,6.135 0.906,0.271 10 Condition [5] 4.99,1.521 6.438,1.771 1.448,0.25 10 Disarmed State (2)*2 1.083,0.885 2.198,1.146 1.115,0.26 10 Disarmed State 3.573,1.25 4.469,1.479 0.896,0.229 10 Condition [9] 3.573,1.906 4.479,2.135 0.906,0.229 10 Condition [8] 4.51,2.531 5.479,2.802 0.969,0.271 10 Condition [7] 4.958,3.469 5.948,3.74 0.99,0.271 10 Condition [10]

w/ Entry and Start System
Condition Item
Condition [1] In disarmed state 1, when the engine switch is turned off, the system state is changed if the following condition is met:
·

With all doors and the hood closed, all doors are locked by wireless operation, the entry and start system.


Condition [2]
·

Approximately 30 seconds elapse.


Condition [3]
·

All doors are unlocked by wireless operation, the entry and start system or key linked power door lock operation.

·

Any door is unlocked.

·

Any door is opened.

·

The engine switch is pushed.

·

The engine switch is turned on (ACC) or on (IG).

·

The battery is reconnected.


Condition [4]
·

The hood is opened when it was closed.

·

The battery is reconnected while the any door or hood is open or any door is unlocked.

·

Any door is opened when all doors are closed.

·

Any door is unlocked when all doors are locked.

·

When 5 seconds or more have elapsed since the engine switch is pressed, the power source mode is changed from off to on (IG) without pressing the engine switch.

·

The hood is open.

·

Any door is opened.

·

The power source mode is on (IG).


Condition [5]
·

The engine switch is turned on (IG) and the engine is running at 550 rpm for 2 seconds or more.

·

All doors are unlocked by wireless operation, the entry and start system or key linked power door lock operation.


Condition [6]
·

After approximately 27.5 seconds, the alarm stops and the system returns to the armed state.


Condition [7]
·

The hood is closed when it was open.


Condition [8]
·

Any door is unlocked when all doors are locked.

·

Any door is opened.

·

The engine switch is pushed.

·

The engine switch is turned on (ACC) or on (IG).

·

The battery is reconnected.

·

All doors are unlocked by wireless operation, the entry and start system or key linked power door lock operation.


Condition [9] In disarmed state 1, when the engine switch is turned off, the system state is changed if the following condition is met:
·

With all doors closed and the hood open, all doors are locked by wireless operation, the entry and start system or key linked power door lock operation.


Condition [10]
·

The hood is opened.



w/o Entry and Start System
Condition Item
Condition [1] In disarmed state 1, when the ignition switch is off, the system state is changed if the following condition is met when the key is not in the key cylinder:
·

With all doors and the hood closed, all doors are locked by wireless operation.


Condition [2]
·

Approximately 30 seconds elapse.


Condition [3]
·

All doors are unlocked by wireless operation or key linked power door lock operation.

·

Any door is unlocked.

·

Any door is opened.

·

Key is in the key cylinder.

·

The ignition switch is turned to ACC or ON.

·

The battery is reconnected.


Condition [4]
·

The hood is opened when it was closed.

·

The battery is reconnected while the hood is open or any door is unlocked.

·

Any door is opened when all doors are closed.

·

Any door is unlocked when all doors are locked.

·

The ignition switch is ON when the key is not in the key cylinder.

·

The hood is open.

·

Any door is opened.


Condition [5]
·

The engine switch is turned on (IG) and the engine is running at 550 rpm for 2 seconds or more.

·

All doors are unlocked by wireless operation or key linked power door lock operation.


Condition [6]
·

After approximately 27.5 seconds, the alarm stops and 5 seconds later the system returns to the armed state.


Condition [7]
·

The hood is closed when it was open.


Condition [8]
·

Any door is unlocked when all doors are locked.

·

Any door is opened.

·

Key is in the key cylinder.

·

The ignition switch is turned to ACC or ON.

·

The battery is reconnected.

·

All doors are unlocked by wireless operation or key linked power door lock operation.


Condition [9] In disarmed state 1, when the ignition switch is off, the system state is changed if the following condition is met when the key is not in the key cylinder:
·

With all doors closed and the hood open, all doors are locked by wireless operation.


Condition [10]
·

The hood is opened.





FORCED DOOR LOCK CONTROL


a.

The forced door lock control prevents the vehicle from being tampered with. Immediately after a door is unlocked (armed state), all doors are forced to lock by a forced door lock signal.

i.

If the following conditions are met, the forced door lock control is operated.

·

The theft deterrent system is in the armed state.

·

Any door is unlocked.





SECURITY INDICATOR LIGHT OUTPUT


a.

According to the state of the theft deterrent system, the main body ECU (multiplex network body ECU) outputs a signal to turn the security indicator light on. However, some of the actual lighting conditions of the security indicator light are different from the output signals of the main body ECU (multiplex network body ECU).

Output
State of Theft Deterrent System Security Indicator Light
Output Signal from Main Body ECU (Multiplex Network Body ECU) Actual Lighting Condition
Disarmed state (1), (2) Off
·

Off (Immobiliser system unset)

·

Blinking (Immobiliser system set)


Arming preparation state On On
Armed state Off Blinking
Alarm sounding state On On

Blinking Cycle
Time Security Indicator Light
0.125 sec. On
1.875 sec. Off

HINT:

When the immobiliser system is set, the security indicator light blinks during both the disarmed state and the armed state due to output signals from the immobiliser system.