The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during clutch pedal stroke sensor assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
87211
3.REMOVE NO. 1 AIR DUCT
89280
4.REMOVE CLUTCH PEDAL STROKE SENSOR ASSEMBLY
Disconnect the connector from the clutch pedal stroke sensor assembly.
Remove the 2 nuts and clutch pedal stroke sensor assembly from the clutch pedal support assembly.
Do not drop the clutch pedal stroke sensor assembly.
If the clutch pedal stroke sensor assembly has been dropped, replace the clutch pedal stroke sensor assembly with a new one.