Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HIGH BEAM SYSTEM › from 2020.08
RM32H0E _59 Vehicle Exterior _060313 LIGHTING (EXT) _0303031 AUTOMATIC HIGH BEAM SYSTEM C

LIGHTING (EXT)  AUTOMATIC HIGH BEAM SYSTEM  U010087  Lost Communication With ECM/PCM "A" Missing Message  U012587  Lost Communication With Multi-axis Acceleration Sensor Module Missing Message  U012687  Lost Communication with Steering Angle Sensor Module Missing Message  U012987  Lost Communication with Brake System Control Module Missing Message  U014087  Lost Communication with Body Control Module Missing Message  


DESCRIPTION

These DTCs are stored if a CAN communication malfunction occurs between the forward recognition camera and other ECUs.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
U010087 Lost Communication With ECM/PCM "A" Missing Message The forward recognition camera does not receive data from the ECM for approximately 5 seconds or more.
·

CAN communication system

·

ECM


-
U012587 Lost Communication With Multi-axis Acceleration Sensor Module Missing Message The airbag ECU assembly (yaw rate sensor) does not receive data from the ECM for approximately 5 seconds or more.
·

CAN communication system

·

Airbag ECU assembly (yaw rate sensor)


-
U012687 Lost Communication with Steering Angle Sensor Module Missing Message The forward recognition camera does not receive data from the steering sensor for approximately 5 seconds or more.
·

CAN communication system

·

Steering sensor


-
U012987 Lost Communication with Brake System Control Module Missing Message

The forward recognition camera does not receive data from the skid control ECU (brake actuator assembly) for approximately 5 seconds or more.


·

CAN communication system

·

Skid control ECU (brake actuator assembly)


-
U014087 Lost Communication with Body Control Module Missing Message The forward recognition camera does not receive data from the main body ECU (multiplex network body ECU) for approximately 5 seconds or more.
·

CAN communication system

·

Main body ECU (multiplex network body ECU)


-

PROCEDURE

1.CLEAR DTC
a.

Enter the following menus: Body Electrical / Front Recognition Camera (Front Lighting Control) / Trouble Codes.


b.

Clear the DTCs.

Body Electrical > Front Recognition Camera (Front Lighting Control) > Clear DTCs
50002 433

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Turn the ignition switch to ON.


b.

Wait 10 seconds or more.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Front Recognition Camera (Front Lighting Control) / Trouble Codes.


e.

Check for DTCs.

Body Electrical > Front Recognition Camera (Front Lighting Control) > Trouble Codes
50001 433

Result:
Result Proceed to
DTC are not output A
U010087, U12587, U012687, U012987 or U014087 are output B
None of the above conditions are met C



A

B

C

GO TO DIAGNOSTIC TROUBLE CODE CHART