Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SEAT POSITION SENSOR › from 2020.08
RM32H0E _58 Vehicle Interior _060061 SUPPLEMENTAL RESTRAINT SYSTEMS _0294203 SEAT POSITION SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  SEAT POSITION SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the seat position airbag sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Panoramic view monitor system (Click here)

NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) battery terminal.


HINT:
·

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: When performing learning using the GTS

Click here(Click here)

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Simple intelligent parking assist system*1
Parking support brake system*1

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -


·

Use the same procedure for RHD and LHD vehicles.

·

The following procedure is for LHD vehicles.



PROCEDURE

Hide 1.REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)

Hide 7181B 2.REMOVE FRONT SEAT CUSHION WIRE HARNESS HOLDER (for Power Seat)

Hide 72277A 3.REMOVE SEAT SLIDE POSITION SENSOR PROTECTOR

a.
B458404

for Manual Seat:

i.

Disengage the clamp.


ii.

Disconnect the connector.



b.
B458405C01
0,0 0,0 false
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


Pull the seat slide position sensor protector in the direction indicated by the arrow (1), to disengage the pin, and then slide the seat slide position sensor protector in the direction indicated by the arrows (2) shown in the illustration to remove it.


Hide 89178A 4.REMOVE SEAT POSITION AIRBAG SENSOR (for Manual Seat)

a.
B458406

Using a T30 "TORX" socket wrench, remove the "TORX" bolt and seat position airbag sensor.


Hide 89178A 5.REMOVE SEAT POSITION AIRBAG SENSOR (for Power Seat)

a.
B558595

Using a T30 "TORX" socket wrench, remove the "TORX" bolt and seat position airbag sensor with bracket.


b.
B558596

Using a T30 "TORX" socket wrench, remove the "TORX" bolt and seat position airbag sensor from the bracket.