Home › Engine / Hybrid System › 3ZR-FAE (FUEL) › FUEL SENDER GAUGE ASSEMBLY › from 2020.08
RM32H0E _51 Engine / Hybrid System _060184 3ZR-FAE FUEL _0295037 FUEL SENDER GAUGE ASSEMBLY A

3ZR-FAE FUEL  FUEL SENDER GAUGE ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: When performing learning using the GTS

Click here(Click here)

Simple intelligent parking assist system*1 Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 77020A 1.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

Hide 83320 2.REMOVE FUEL SENDER GAUGE ASSEMBLY

a.
A395517

Disconnect the fuel sender gauge assembly connector.


b.

Disengage the 3 clamps to disconnect the wire harness.

NOTICE:

Do not damage the wire harness.



c.
A395516

Disengage the claw to remove the fuel sender gauge assembly from the fuel suction tube with pump and gauge assembly.

NOTICE:

Be careful not to bend the arm of the fuel sender gauge assembly.