When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is operated normally
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Loosen the nut and disconnect the cable from the negative (-) battery terminal.
28800
3.REMOVE BATTERY
Disengage the 2 claws to remove the fusible link cover.
Loosen the nut.
Disengage the clamp and disconnect the cable from the positive (+) battery terminal.
Remove the battery insulator from the battery.
Remove the bolt and No. 2 battery clamp.
Remove the battery from the vehicle.