Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
75743A
1.INSTALL REAR DOOR UPPER REAR OUTSIDE MOULDING (w/ Plated Moulding)
When using a new rear door outside moulding:
Clean the surface of the rear door outside moulding.
When reusing the rear door outside moulding:
Remove the double-sided tape from the rear door outside moulding.
Wipe off any tape adhesive residue with cleaner.
Install a new rear door upper rear outside moulding.
Remove the release paper from the rear door upper rear outside moulding.
After removing the release paper, keep the exposed adhesive free from foreign matter.
| *a | Mark-off Line |
| *b | Rear Door Outside Moulding Edge |
| *c | 2.2 mm (0.0866 in.) |
| *d | 1.0 mm (0.0394 in.) |
Install the rear door upper rear outside moulding as shown in the illustration.
75743A
2.INSTALL REAR DOOR UPPER REAR OUTSIDE MOULDING (for GR SPORT)
Engage the claws to install the rear door upper rear outside moulding.
75393
3.INSTALL NO. 2 OUTSIDE MOULDING RETAINER (for TMMT Made)
When using a new rear door outside moulding:
Clean the surface of a new rear door outside moulding.
When reusing the rear door outside moulding:
Remove the double-sided tape from the rear door outside moulding.
Wipe off any tape adhesive residue with cleaner.
Install a new No. 2 outside moulding retainer.
Remove the release paper from the No. 2 outside moulding retainer.
After removing the release paper, keep the exposed adhesive free from foreign matter.
| *a | Mark-off Line |
| *b | 4.0 mm (0.157 in.) |
Install the No. 2 outside moulding retainer as shown in the illustration.
75797
4.INSTALL REAR DOOR UPPER OUTSIDE MOULDING PAD
When using a new rear door outside moulding:
Clean the surface of a new rear door outside moulding.
When reusing the rear door outside moulding:
Remove the double-sided tape from the rear door outside moulding.
Wipe off any tape adhesive residue with cleaner.
Install a new rear door upper outside moulding pad.
Remove the release paper from the rear door upper outside moulding pad.
After removing the release paper, keep the exposed adhesive free from foreign matter.
| *a | Mark-off Line |
| *b | 3.0 mm (0.118 in.) |
| *c | 13 mm (0.512 in.) |
Install the rear door upper outside moulding pad as shown in the illustration.