Home › Vehicle Exterior › LIGHTING (EXT) › FOG LIGHT ASSEMBLY › from 2021.09
RM32H0E _59 Vehicle Exterior _060313 LIGHTING (EXT) _0295715 FOG LIGHT ASSEMBLY G

LIGHTING (EXT)  FOG LIGHT ASSEMBLY  INSPECTION  


PROCEDURE

Hide 8121C 1.INSPECT FOG LIGHT LED LH (for LED Type)

a.

Check that the fog light LED LH.

i.
E437432C07
0.979,1.802 1.594,1.219 true 2.479,1.771 1.865,1.229 true 0.344,0.26 0.656,0.458 0.313,0.198 10 false *a 0.938,1.833 1.281,2.083 0.344,0.25 10 false B 2.51,1.813 2.854,2.063 0.344,0.25 10 false E
*a Component without harness connected
(Fog Light LED LH)


Apply battery voltage to the fog light LED LH and check that the light comes on.

OK:
Condition Specified Condition
Battery positive (+) → Terminal 2 (B)
Battery negative (-) → Terminal 1 (E)
Fog light LED comes on


If the result is not as specified, replace the fog light LED LH.



Hide 8121C 2.INSPECT FOG LIGHT LED RH (for LED Type)

a.

Check that the fog light LED RH.

i.
E437432C08
0.979,1.802 1.563,1.208 true 2.479,1.771 1.854,1.208 true 0.344,0.26 0.656,0.458 0.313,0.198 10 false *a 0.938,1.833 1.281,2.083 0.344,0.25 10 false B 2.51,1.813 2.854,2.063 0.344,0.25 10 false E
*a Component without harness connected
(Fog Light LED RH)


Apply battery voltage to the fog light LED RH and check that the light comes on.

OK:
Condition Specified Condition
Battery positive (+) → Terminal 2 (B)
Battery negative (-) → Terminal 1 (E)
Fog light LED comes on


If the result is not as specified, replace the fog light LED RH.