DISASSEMBLY
Removal / installation · Vehicles built from Jun 2009
| 1.
REMOVE FRONT BRAKE PAD |
 |
Remove the 2 brake pads from the front disc brake cylinder mounting.
| 2.
REMOVE FRONT DISC BRAKE PAD SUPPORT PLATE |
 |
Remove the 2 front disc brake pad support plates.
| 3.
REMOVE FRONT DISC BRAKE CYLINDER MOUNTING |
 |
- Remove the 2 bolts and front disc brake cylinder mounting.
| 4.
REMOVE FRONT DISC BRAKE CYLINDER SLIDE PIN |
 |
- Remove the front disc brake cylinder slide pins from the front disc brake cylinder mounting.
| 5.
REMOVE FRONT DISC BRAKE BUSHING DUST BOOT |
 |
- Remove the 2 front disc brake bushing dust boots from the front disc brake cylinder mounting.
| 6.
REMOVE FRONT DISC BRAKE PISTON |
 |
- Prepare a wooden plate to hold the front disc brake pistons.
Place the wooden plate between the front disc brake piston and the disc brake cylinder assembly.
- Use compressed air to remove the front disc brake piston from the disc brake cylinder assembly.
- CAUTION:
- Do not place your fingers in front of the piston when using compressed air.
- NOTICE:
- Do not spatter the brake fluid.
| 7.
REMOVE CYLINDER BOOT |
 |
Remove the cylinder boot from the disc brake cylinder assembly.
| 8.
REMOVE PISTON SEAL |
 |
- Using a screwdriver, remove the piston seal from the disc brake cylinder assembly.
- NOTICE:
- Do not damage the inner cylinder or cylinder groove.
- HINT:
- Tape the screwdriver tip before use.
| 9.
REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP |
|
| 10.
REMOVE FRONT DISC BRAKE BLEEDER PLUG |
|
| 11.
REMOVE FRONT DISC |
 |
- Remove the front disc.
- HINT:
- Put matchmarks on the disc and the axle hub.