Disengage the 4 clips and 5 claws and remove the No. 2 package tray trim panel assembly.
26.
REMOVE REAR ASSIST GRIP SUB-ASSEMBLY
HINT:
Use the same procedure for the rear side and the front side.
27.
REMOVE SPOT LIGHT ASSEMBLY (w/ Sliding Roof)
Using a screwdriver, disengage the 2 claws labeled A and 2 claws labeled B from the vehicle body.
HINT:
Tape the screwdriver tip before use.
Using a screwdriver, disengage the 2 claws labeled C and remove the spot light assembly from the headlining.
HINT:
Tape the screwdriver tip before use.
Using a screwdriver, disengage the 4 claws.
HINT:
Tape the screwdriver tip before use.
Pull the light bulb holder in the direction indicated by the arrow in the illustration to detach the claw. Then remove the spot light assembly from the light bulb holder.
It is not necessary to completely remove the roof headlining. Slightly lower the rear section of the roof headlining so that the back window glass can be removed (Click here).
It is not necessary to completely remove the roof headlining. Slightly lower the rear section of the roof headlining so that the back window glass can be removed (Click here).
30.
REMOVE BACK WINDOW MOULDING
Using a knife, cut off the moulding, as shown in the illustration.
NOTICE:
Do not damage the vehicle body with the knife.
If the vehicle body is damaged, repair the damaged portion by applying an anti-rust coating after removing the back window glass.
Remove the remaining moulding from the back window glass.
HINT:
When removing the moulding, make a partial cut, then pull and remove it by hand.
31.
REMOVE BACK WINDOW GLASS ASSEMBLY
NOTICE:
There are No. 1 and No. 2 stoppers on the back window glass as shown in the illustration. Be careful not to damage the back window glass when cutting off the adhesive.
To prevent the back window glass from dropping when performing this operation, be sure to hold the back window glass using suction cups.
HINT:
Depending on vehicles, a 1-piece or 2-piece type stopper is used.
Disconnect the connector.
Disconnect the connectors.
Apply protective tape to the installation position of the back window glass assembly on the vehicle body.
HINT:
Apply protective tape to the installation surface to prevent it from being scratched.
Pass a piano wire between the vehicle body and glass from the interior.
Tie both wire ends to wooden blocks or similar objects.
Cut off the adhesive by pulling the piano wire around the back window glass.
NOTICE:
When separating the back window glass, take care not to damage the paint or the interior and exterior ornaments.
To prevent the package tray from being scratched when removing the back window glass, place a plastic sheet between the piano wire and package tray.
Place matchmarks on the back window glass and vehicle body on the locations indicated in the illustration.
HINT:
Matchmarks do not need to be placed if the back window glass is not going to be reused.
Using a suction cup, remove the back window glass assembly.
NOTICE:
Be careful not to drop the back window glass.
Leave as much adhesive on the vehicle body as possible when removing the back window glass.
32.
REMOVE NO. 2 BACK WINDOW GLASS STOPPER
Using a scraper, remove the 2 No. 2 stoppers.
NOTICE:
Be careful not to damage the back window glass.
Be sure to replace the No. 2 stoppers with new ones.