2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Noise Occurs

Circuit diagnosis · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

INSPECTION PROCEDURE


1. NOISE CONDITION
  1. Check from which direction the noise comes (front left or right, or rear left or right).

    OK:
    The location of the noise source can be determined.



NG
Go to step 3
OK


2. CHECK SPEAKERS
  1. Check the installation conditions of the speaker units that are located near the noise source and that there are no cracks, scratches, deformation or other failures.

    Result:
    Result
    Proceed to
    No malfunction is found
    A
    A speaker is installed incorrectly
    B
    Foreign objects are in the speaker
    C
    A speaker cone paper is broken
    D



B
REINSTALL SPEAKER

C
REMOVE FOREIGN OBJECT

D
REPLACE SPEAKER
A


3. CHECK NOISE CONDITIONS
  1. Check the noise condition.

    HINT:
    The radio has a noise prevention function to reduce noise when listening to the radio. If a loud noise occurs, check whether the ground at the antenna mounting base and the noise prevention unit are installed and wired correctly.

    Condition under which Noise Occurs
    Noise Source
    Noise increases when the accelerator pedal is depressed, but stops when the engine is stopped.
    Generator
    Noise occurs during A/C or heater operation.
    Blower motor
    Noise occurs when the horn switch is pressed and released or when pressed and held.
    Horn
    Noise occurs synchronously with the turn signal blinking pattern.
    Flasher
    Noise occurs during window washer operation.
    Washer
    Noise occurs during wiper operation.
    Wiper
    Noise occurs when the brake pedal is depressed.
    Stop light switch
    Others
    Static electricity

    HINT:
    1. In the left column of the table, find the situation that matches the customer's complaint. Then, in the right column, find the part that is causing the noise. Check the respective noise filter.
    2. To save time and avoid a misdiagnosis, first make sure that the noise is not coming from outside the vehicle.
    3. Troubleshoot noises in descending order of loudness.
    4. Setting the radio to a frequency where no signal is received may make recognition of the noise problem easier.

    OK:
    The noise source cannot be determined.



NG
REPAIR OR REPLACE NOISE SOURCE
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Noise Occurs (Oct 2006 – May 2009)Pressing Power Switch does not Turn on System (Jun 2006 – May 2009) →