Using a screwdriver with the tip wrapped with protective tape, disengage the claw and remove the courtesy light assembly.
Disconnect the connector.
5.
REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
Remove the 3 screws and clip (A).
Using a clip remover, disengage the 9 clips.
Pull up the front door trim board in the direction indicated by the arrow.
Disengage the reference bosses from the front door panel.
Raise the front door trim board to disengage the 4 claws and remove the front door trim board together with the front door inner glass weatherstrip.
Disengage the 2 claws and disconnect the front door inside handle sub-assembly.
6.
REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP
Using a screwdriver, disengage the 4 clips as shown in the illustration and remove the front door inner glass weatherstrip from the front door trim board.
7.
REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY
Disconnect the front door lock remote control cable and front door inside locking cable and remove the front door inside handle sub-assembly.
8.
REMOVE FRONT NO. 1 SPEAKER ASSEMBLY
Disconnect the connector.
Remove the 4 bolts and front No. 1 speaker assembly.
NOTICE:
Do not touch the cone part of the speaker.
9.
REMOVE OUTER REAR VIEW MIRROR ASSEMBLY
Disconnect the connector.
Remove the 3 nuts and the outer rear view mirror assembly.
10.
REMOVE FRONT DOOR SERVICE HOLE COVER
Disconnect the connector and each clamp, and remove the front door service hole cover.
HINT:
Remove the remaining butyl tape on the door.
11.
REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
Connect the front power window regulator motor assembly connector.
Connect the power window regulator master switch assembly and move the front door glass sub-assembly so that the door glass bolts can be seen.
Remove the 2 bolts.
NOTICE:
After the bolts are removed, the door glass may fall, causing damage.
Remove the front door glass sub-assembly as shown in the illustration.
NOTICE:
Do not damage the door glass.
Disconnect the power window regulator master switch assembly and front power window regulator motor assembly connector.
12.
REMOVE FRONT DOOR GLASS RUN
Remove the front door glass run.
13.
REMOVE FRONT DOOR WEATHERSTRIP
Using a clip remover, disengage the clip and remove the front door weatherstrip.
HINT:
Tape the clip remover tip before use.
14.
REMOVE DOOR FRAME GARNISH
Disengage the clip and remove the door frame garnish.
15.
REMOVE FRONT DOOR STRIPE
Using a heat light, heat the front door stripe.
Heating temperature:
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
NOTICE:
Do not heat the vehicle body excessively.
Pull back an edge of the front door stripe and pull it parallel to the vehicle body to pull it off.
16.
REMOVE FRONT DOOR LOWER OUTSIDE STRIPE
Using a heat light, heat the front door lower outside stripe.
Heating temperature:
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
NOTICE:
Do not heat the vehicle body excessively.
Pull back an edge of the front door lower outside stripe and pull it parallel to the vehicle body to pull it off.