2006-2011 Camry Aurion · Service Manual ENGINE

CHECK MODE PROCEDURE

Troubleshooting · Vehicles built Jun 2006 – May 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009

HINT:
Intelligent tester only:
Compared to normal mode, check mode is more sensitive to malfunctions. Therefore, check mode can detect the malfunctions that cannot be detected by normal mode.

NOTICE:
All the stored DTCs and freeze frame data are erased if: 1) the ECM is changed from normal mode to check mode or vice versa; or 2) the ignition switch is turned from ON to ACC or off while in check mode. Before changing modes, always check and make a note of any DTCs and freeze frame data.


CHECK MODE PROCEDURE (Using intelligent tester)

  1. B139188E08
    Check and ensure the following conditions:

    1. Battery positive voltage 11 V or more.

    2. Throttle valve fully closed.

    3. Transmission in the P or N position.

    4. A/C switch off.

  2. Turn the ignition switch off.

  3. Connect the intelligent tester to the DLC3.

  4. Turn the ignition switch to the ON position and turn the tester on.

  5. Select the following menu items: Utility / Check Mode.

  6. Switch the ECM from normal mode to check mode.

  7. A076900E04
    Make sure that the MIL flashes as shown in the illustration.

  8. Start the engine.

  9. Make sure that the MIL turns off.

  10. Simulate the conditions of the malfunction described by the customer.

  11. Check for DTCs and freeze frame data using the tester.

← FREEZE FRAME DATA (from Jun 2009)CHECK MODE PROCEDURE (from Jun 2009) →