P0010 Camshaft Position "A" Actuator Circuit (Bank 1)
Diagnostic trouble codes · Vehicles built from Jun 2006
DESCRIPTION
- HINT:
- This DTC relates to the Oil Control Valve (OCV).


| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0010 |
Open or short in OCV circuit (1-trip detection logic) |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (OPERATE OCV) |
Connect the intelligent tester to the DLC3.
Start the engine and turn the tester on.
Warm up the engine.
Select the following menu items: Powertrain / Engine and ECT / Active Test / Control the VVT System (Bank 1).
Check the engine speed while operating the Oil Control Valve (OCV) using the tester.
- OK:
Tester Operation
Specified Condition
OCV OFF
Normal engine speed
OCV ON
Engine idles roughly or stalls
(soon after OCV switched from OFF to ON)
|
|
||||
| OK | ||
| ||
| 2. INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY |
Disconnect the C32 OCV connector.

Measure the resistance between the terminals of the OCV.
- Standard resistance:
- 6.9 to 7.9 Ω at 20°C (68°F)
Reconnect the OCV connector.
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (OCV - ECM) |
Disconnect the C32 OCV connector.

Disconnect the C24 ECM connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance (Check for open):
Tester Connection
Specified Condition
OC1+ (C32-1) - OC1+ (C24-100)
Below 1 Ω
OC1- (C32-2) - OC1- (C24-123)
- Standard resistance (Check for short):
Tester Connection
Specified Condition
OC1+ (C32-1) or OC1+ (C24-100) - Body ground
10 kΩ or higher
OC1- (C32-2) or OC1- (C24-123) - Body ground
Reconnect the OCV connector.
Reconnect the ECM connector.
|
|
||||
| OK | ||
| ||
