2006-2011 Camry Aurion · Service Manual CRUISE CONTROL SYSTEM

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Jun 2006 – Sep 2006

HINT:
  1. Use the following procedures to troubleshoot the cruise control system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.PROBLEM SYMPTOM CONFIRMATION
      NEXT

      3.CHECK CAN COMMUNICATION SYSTEM*
        Refer to PRECAUTION (Click here).
      1. Check for output DTCs.

        Result:
        Result
        Proceed to
        CAN DTC is not output
        A
        CAN DTC is output
        B

        HINT:
        The ECM of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.


      B.
      A

      4.DTC CHECK AND CLEAR*
        Refer to DTC CHECK / CLEAR (Click here).
      NEXT

      5.DTC CHECK (OTHER THAN CAN SYSTEM DTC)*

        Result:
        Result
        Proceed to
        DTC is not output
        A
        DTC is output
        B


      A.
      B

      6.DTC CHART
        Refer to DIAGNOSTIC TROUBLE CODE CHART (Click here).
      NEXT

      7.PROBLEM SYMPTOM CONFIRMATION

        Result:
        Result
        Proceed to
        Symptom occurs
        A
        Symptom does not occur
        B


      A.
      B

      8.SYMPTOM SIMULATION
        Refer to ELECTRONIC CIRCUIT INSPECTION PROCEDURE (Click here).
      NEXT

      9.PROBLEM SYMPTOMS TABLE
        Refer to PROBLEM SYMPTOMS TABLE (Click here).
      NEXT

      10.CIRCUIT INSPECTION
        NEXT

        11.TERMINALS OF ECM
          Refer to TERMINALS OF ECM (Click here).
        NEXT

        12.IDENTIFICATION OF PROBLEM
          NEXT

          13.REPAIR OR REPLACE
            NEXT

            14.CONFIRMATION TEST
              NEXT

              ← SYSTEM DESCRIPTION (Jun 2006 – Sep 2006)ROAD TEST (Jun 2006 – Sep 2006) →