Circuit diagnosis · Vehicles built Oct 2006 – May 2009
Versions by build date: Oct 2006 – May 2009from Jun 2009
DESCRIPTION
The ECM detects a cruise control switch signal and sends it to the combination meter through CAN. Then the CRUISE main indicator light comes on.
The CRUISE main indicator light circuit uses CAN for communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.
INSPECTION PROCEDURE
1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
Connect the intelligent tester to the DLC3.
Check the CRUISE main indicator light by performing the ACTIVE TEST.
Combination meter:
Tester Display
Test Part
Control Range
Normal Condition
Indicat. Lamp Cruise
CRUISE main indicator light
Indicator light BLINK / OFF
-
OK:
Indicator light blinks/goes off.
NG
REPLACE COMBINATION METER ASSEMBLY
OK
2. READ VALUE USING INTELLIGENT TESTER
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the intelligent tester main switch on.
Check the DATA LIST for proper functioning of the CRUISE main indicator light.
ECM (Cruise control):
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
CCS Indicator M
Cruise indicator signal (Main CPU) / ON or OFF
ON: "CRUISE" on OFF: "CRUISE" off
-
OK:
When the cruise control main switch is operated, the display changes as shown above.