DATA LIST / ACTIVE TEST
System information · Vehicles built from Oct 2006
Versions by build date: Jun 2006 – Sep 2006 from Oct 2006
| DATA LIST |
- HINT:
- Using the intelligent tester's Data List allows switch, sensor, actuator, and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save time.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Turn the tester on.
Enter the following menus: Body / Air Conditioner / Data List.
Check the value(s) by referring to the table below.
Air Conditioner (for Manual A/C) Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Ambient Temp Sensor
(Ambi Temp Sens)
Ambient temperature sensor / Min.: -23.3°C (-9.94°F), Max.: 65.95°C (150.71°F)
Actual ambient temperature is displayed
-
Adjusted Ambient Temp
(Ambi Temp)
Adjusted ambient temperature / Min.: -30.8°C (-23.44°F), Max.: 50.8°C (123.44°F)
-
-
Evaporator Fin Thermistor
(Evap Fin Temp)
Evaporator fin thermistor / Min.: -29.7°C (-21.46°F), Max.: 59.55°C (139.19°F)
Actual evaporator temperature is displayed
-
Engine Coolant Temp
(Coolant Temp)
Engine coolant temperature / Min.: 1.3°C (34.34°F), Max.: 90.55°C (194.99°F)
Actual engine coolant temperature is displayed while engine is warmed up
-
Regulator Pressure Sensor
(Reg Press Sens)
Regulator pressure sensor / Min.: 0.5 kgf/cm2G, Max.: 37.75 kgf/cm2G
Actual refrigerant pressure is displayed
-
Regulator Control Current
(Reg Ctrl Currnt)
Compressor variable output current / Min.: 0 A, Max.: 0.996 A
-
-
Air Mix Servo Target Pulse(D)
(Air Mix Pulse-D)
Driver side air mix servo motor target pulse / Min.: 0, Max.: 255
MAX. COLD: 105 (pulse)
MAX. HOT: 7 (pulse)
-
Air Outlet Servo Pulse(D)
(Air Out Pulse-D)
Driver side air outlet servo motor target pulse / Min.: 0, Max.: 255
FACE: 8 (pulse)
B/L: 30 to 38 (pulse)
FOOT: 50 to 74 (pulse)
FOOT/DEF: 80 (pulse)
DEF: 97 (pulse)
-
Air Inlet Damper Target Pulse
(A/I Damp Targ Pls)
Air inlet damper target pulse / Min.: 0, Max.: 255
RECIRCULATION: 7 (pulse)
FRESH: 28 (pulse)
-
Number of Trouble Codes
(# Codes)
Number of trouble codes / Min.: 0, Max.: 255
Number of DTCs will be displayed
-
Air Conditioner (for Automatic A/C) Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Room Temperature Sensor
(Room Temp)
Room temperature sensor / Min.: -6.5°C (20.3°F), Max.: 57.25°C (135.05°F)
Actual cabin temperature is displayed
-
Ambient Temp Sensor
(Ambi Temp Sens)
Ambient temperature sensor / Min.: -23.3°C (-9.94°F), Max.: 65.95°C (150.71°F)
Actual ambient temperature is displayed
-
Adjusted Ambient Temp
(Ambi Temp)
Adjusted ambient temperature / Min.: -30.8°C (-23.44°F), Max.: 50.8°C (123.44°F)
-
-
Evaporator Fin Thermistor
(Evap Fin Temp)
Evaporator fin thermistor / Min.: -29.7°C (-21.46°F), Max.: 59.55°C (139.19°F)
Actual evaporator temperature is displayed
-
Solar Sensor (D side)
(Solar Sens-D)
Driver side solar sensor / Min.: 0, Max.: 255
Driver side solar sensor value increases as brightness increases
-
Solar Sensor (P side)
(Solar Sens-P)
Passenger side solar sensor / Min.: 0, Max.: 255
Passenger side solar sensor value increases as brightness increases
-
Engine Coolant Temp
(Coolant Temp)
Engine coolant temperature / Min.: 1.3°C (34.34°F), Max.: 90.55°C (194.99°F)
Actual engine coolant temperature is displayed while engine is warmed up
-
Set Temperature (D side)
(Set Temp-D)
Driver side set temperature / Min.: 0°C (32°F), Max.: 30°C (54°F)
Driver side set temperature is displayed
-
Set Temperature (P side)
(Set Temp-P)
Passenger side set temperature / Min.: 0°C (32°F), Max.: 30°C (54°F)
Passenger side set temperature is displayed
-
Estimated Temp-D
(Estimate Temp-D)
Driver side estimate temperature / Min.: -358.4°C (-613.12°F), Max.: 358.4°C (677.12°F)
Damper is at "MAX. COOL": -358.4°C (-613.12°F)
Damper is at "MAX. HOT": 358.4°C (677.12°F)
-
Estimated Temp-P
(Estimate Temp-P)
Passenger side estimate temperature / Min.: -358.4°C (-613.12°F), Max.: 358.4°C (677.12°F)
Damper is at "MAX. COOL": -358.4°C (-613.12°F)
Damper is at "MAX. HOT": 358.4°C (677.12°F)
-
Hand Free Telephone
(Hand Free Tel)
Hands free telephone / OFF or ON
-
-
Blower Motor Speed Level
(Blower Level)
Blower motor speed level / Min.: 0 level, Max.: 31 level
Increases in the range between 0 and 31 as the blower motor speed increases
-
Regulator Pressure Sensor
(Reg Press Sens)
Regulator pressure sensor / Min.: 0.5 kgf/cm2G, Max.: 37.75 kgf/cm2G
Actual refrigerant pressure is displayed
-
Regulator Control Current
(Reg Ctrl Currnt)
Compressor variable output current / Min.: 0 A, Max.: 0.996 A
-
-
Air Mix Servo Target Pulse(D)
(Air Mix Pulse-D)
Driver side air mix servo motor target pulse / Min.: 0, Max.: 255
LHD:
MAX. COLD: 5 (pulse)
MAX. HOT: 103 (pulse)
RHD:
MAX. COLD: 105 (pulse)
MAX. HOT: 7 (pulse)
-
Air Mix Servo Targ Pulse(P)
(Air Mix Pulse-P)
Passenger side air mix servo motor target pulse / Min.: 0, Max.: 255
LHD:
MAX. COLD: 105 (pulse)
MAX. HOT: 7 (pulse)
RHD:
MAX. COLD: 5 (pulse)
MAX. HOT: 103 (pulse)
-
Air Outlet Servo Pulse(D)
(Air Out Pulse-D)
Driver side air outlet servo motor target pulse / Min.: 0, Max.: 255
FACE: 8 (pulse)
B/L: 30 to 38 (pulse)
FOOT: 50 to 74 (pulse)
FOOT/DEF: 80 (pulse)
DEF: 97 (pulse)
-
Air Inlet Damper Target Pulse
(A/I Damp Targ Pls)
Air inlet damper target pulse / Min.: 0, Max.: 255
RECIRCULATION: 7 (pulse)
FRESH: 28 (pulse)
-
Number of Trouble Codes
(# Codes)
Number of trouble codes / Min.: 0, Max.: 255
Number of DTCs will be displayed
-
Engine Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
A/C Signal
(A/C Signal)
A/C signal / ON or OFF
ON: A/C ON
OFF: A/C OFF
-
| ACTIVE TEST |
- HINT:
- Performing the intelligent tester's Active Test allows relays, VSVs, actuators and other items to be operated without removing any parts. Performing the Active Test early in troubleshooting is one way to save time. The Data List can be displayed in the Active Test.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Turn the tester on.
Enter the following menus: Body / Air Conditioner / Active Test.
Perform the Active Test by referring to the table below.
Air Conditioner (for Manual A/C) Tester Display
Test Part
Control Range
Blower Motor
(Blower Motor)
Blower motor / Min.: Level 0, Max.: Level 31
-
Defogger Relay (Rear)
(Defogger Rly-R)
Defogger relay (Rear) / OFF, ON
-
Air Mix Servo Targ Pulse(D)
(Air Mix Pulse-D)
Driver side air mix servo motor pulse / Min.: 0, Max.: 255
-
Air Outlet Servo Pulse(D)
(Air Out Pulse-D)
Driver side air outlet servo motor pulse / Min.: 0, Max.: 255
-
Air Inlet Damper Targ Pulse
(A/I Damp Targ Pls)
Air inlet damper target pulse / Min.: 0, Max.: 255
-
Air Conditioner (for Automatic A/C) Tester Display
Test Part
Control Range
Blower Motor
(Blower Motor)
Blower motor / Min.: Level 0, Max.: Level 31
-
Defogger Relay (Rear)
(Defogger Rly-R)
Defogger relay (Rear) / OFF, ON
-
Air Mix Servo Targ Pulse(D)
(Air Mix Pulse-D)
Driver side air mix servo motor pulse / Min.: 0, Max.: 255
-
Air Mix Servo Targ Pulse(P)
(Air Mix Pulse-P)
Passenger side air mix servo motor pulse / Min.: 0, Max.: 255
-
Air Outlet Servo Pulse(D)
(Air Out Pulse-D)
Driver side air outlet servo motor pulse / Min.: 0, Max.: 255
-
Air Inlet Damper Targ Pulse
(A/I Damp Targ Pls)
Air inlet damper target pulse / Min.: 0, Max.: 255
-