2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Touch Panel Switch does not Function

Circuit diagnosis · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

INSPECTION PROCEDURE


1. CHECK MULTI-DISPLAY
  1. Check if there is any foreign matter caught between the display and exterior frame of the multi-display.

    OK:
    No foreign matter is caught between the display and exterior frame of the multi-display.

    HINT:
    If there is foreign matter between the display and exterior frame of the multi-display, the touch panel will remain pressed, preventing touch switch operation.



NG
REMOVE FOREIGN MATTER
OK


2. CHECK TOUCH PANEL
  1. Check for foreign matter on the display.

    OK:
    The display is clean.



NG
CLEAN DISPLAY AND RECHECK TOUCH PANEL
OK


3. CHECK TOUCH SWITCH (OPERATION CHECK)

  1. E176521
    Enter the "Touch Switch Check" screen (Check Touch Switch) (Click here).

  1. Touch the display in the area where the switch malfunction occurs.

    OK:
    A "+" mark appears at the touched position.

    Result:
    Result
    Proceed to
    NG
    A
    OK
    (for 2GR-FE RHD)
    B
    OK
    (except 2GR-FE RHD)
    C



B
REPLACE NAVIGATION RECEIVER ASSEMBLY (for 2GR-FE RHD) (Click here)

C
REPLACE NAVIGATION RECEIVER ASSEMBLY (except 2GR-FE RHD) (Click here)
A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Touch Panel Switch does not Function (Oct 2006 – May 2009)Display Panel does not Open, Tilt or Tilts Improperly (Jun 2006 – May 2009) →