Cellular Phone cannot Send/Receive
Circuit diagnosis · Vehicles built Jun 2006 – May 2009
Versions by build date: Jun 2006 – May 2009 from Jun 2009
INSPECTION PROCEDURE
| 1. CHECK "BLUETOOTH" SETTINGS |
 |
Check if the "Bluetooth" settings are correct.
- OK:
- "Bluetooth" settings are correct.
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 2. CHECK CELLULAR PHONE |
 |
Check if the cellular phone is "Bluetooth" compatible.
- HINT:
- Some versions of "Bluetooth" compatible cellular phones may not function.
- OK:
- The phone is "Bluetooth" compatible.
|
NG |
 |
|
| END (ONLY A "BLUETOOTH" COMPATIBLE CELLULAR PHONE CAN BE USED) |
|
|
| OK |
|
 |
|
| 3. CHECK SETTINGS |
 |
Check if the cellular phone functions.
- HINT:
- The cellular phone is unable to call under any of the following conditions:
- The cellular phone is locked.
- The directory is being transferred.
- The line is crossed.
- Transmission is regulated.
- The power is off.
- The cellular phone is not connected to "Bluetooth" ("BT" is displayed while connected).
- OK:
- None of the above conditions exist.
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 4. CHECK CELLULAR PHONE |
 |
Check if the cellular phone can make a call.
- HINT:
- When the battery is low, calls cannot be made or received.
- OK:
- Cellular phone can make a call.
|
NG |
 |
|
| REPAIR OR REPLACE CELLULAR PHONE |
|
|
| OK |
|
 |
|
| 5. CHECK RECEPTION |
 |
Set the cellular phone so that it can receive calls.
Place the cellular phone close to the navigation receiver assembly.
Check if the cellular phone has reception according to the navigation receiver assembly.
- OK:
- Cellular phone has reception.
|
NG |
 |
|
| REPLACE NAVIGATION RECEIVER ASSEMBLY |
|
|
| OK |
|
 |
|
| PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE |
|