B2784 Antenna Coil Open / Short
Diagnostic trouble codes · Vehicles built from Jun 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
This DTC is output when there is an open or short in the key coil (built into the engine switch).
DTC No.
|
DTC Detection Condition
|
Trouble Area
|
B2784
|
Antenna coil is open/shorted
|
- Wire harness
- Certification ECU
- Engine switch
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- If the certification ECU or ID code box is replaced, register the key and ECU communication ID.
| 1. CHECK DTC OUTPUT |
 |
Delete the DTCs (Click here).
Recheck for DTCs (Click here).
- Result:
Result
|
Proceed to
|
B2784 output recurs
|
A
|
B2784 output does not recur
|
B
|
|
B |
 |
|
| USE SIMULATION METHOD TO CHECK |
|
|
| A |
|
 |
|
| 2. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ENGINE SWITCH) |
 |
- Disconnect the E58 ECU and E52 switch connectors.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
|
Condition
|
Specified Condition
|
E58-9 (CODE) - E52-10 (CODE)
|
Always
|
Below 1 Ω
|
E58-8 (TXCT) - E52-9 (TXCT)
|
Always
|
Below 1 Ω
|
E58-9 (CODE) - Body ground
|
Always
|
10 kΩ or higher
|
E58-8 (TXCT) - Body ground
|
Always
|
10 kΩ or higher
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| 3. REPLACE ENGINE SWITCH |
 |
Replace the engine switch (Click here for 2GR-FE, Click here for 2AZ-FE).
| NEXT |
|
 |
|
| 4. CHECK ENGINE START |
 |
Check that the engine starts.
- OK:
- The engine starts.
|
NG |
 |
|
| REPLACE CERTIFICATION ECU |
|
|
| OK |
|
 |
|
|