2006-2011 Camry Aurion · Service Manual HEATER & AIR CONDITIONING SYSTEM

B1442/42 Air Inlet Damper Control Servo Motor Circuit

Diagnostic trouble codes · Vehicles built Jun 2006 – Sep 2006

Versions by build date: Jun 2006 – Sep 2006 from Oct 2006

DESCRIPTION

The damper servo (air inlet control) sends pulse signals to inform the air conditioning amplifier of the damper position. The air conditioning amplifier activates the motor (normal, reverse) based on the signals to move the air inlet damper to any position, which controls the intake air settings (FRESH, FRESH/RECIRCULATION, and RECIRCULATION).

HINT:
Confirm that no mechanical problem is present because this diagnostic code can be output when either a damper link or damper is mechanically locked.

DTC No.
DTC Detection Condition
Trouble Area
B1442/42
Air inlet damper position sensor value does not change even if air conditioning amplifier operates air inlet control servo motor
  1. Air inlet control servo motor
  2. Air conditioning harness
  3. A/C amplifier

WIRING DIAGRAM

E116879E10

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position and turn the intelligent tester main switch on.

  1. Operate the R/F (Recirculation/Fresh) switch.

  1. Select the item below in the Data List, and read the display on the intelligent tester.

Data List / Air Conditioner: 
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Air Inlet Damper Targ Pulse
(A/I Damp Targ Pls)
Air inlet damper target pulse / Min.: 0, Max.: 255
RECIRCULATION: 7 (pulse)
FRESH: 28 (pulse)
-

OK:
The display is as specified in the normal condition column.


Result:
Result
Proceed to
NG
A
OK (When troubleshooting according to the PROBLEM SYMPTOMS TABLE)
B
OK (When troubleshooting according to the DTC)
C



B
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

C
REPLACE AIR CONDITIONING AMPLIFIER
A


2. REPLACE AIR INLET CONTROL SERVO MOTOR
  1. Replace the air inlet control servo motor.

    HINT:
    Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a normal one and check that the condition returns to normal.

  1. Check for DTCs.

    Result:
    Result
    Proceed to
    DTC B1442/42 is output
    A
    DTC B1442/42 is not output
    B



B
END
A

REPLACE AIR CONDITIONING HARNESS


← B1441/41 Air Mix Damper Control Servo Motor Circuit (Passenger Side) (from Oct 2006)B1442/42 Air Inlet Damper Control Servo Motor Circuit (from Oct 2006) →