2006-2011 Camry Aurion · Service Manual TRANSMISSION

P0560 System Voltage

Diagnostic trouble codes · Vehicles built from Oct 2006

DESCRIPTION

The battery supplies electricity to the TCM even when the ignition switch is off. This power allows the TCM to store data such as DTC history, freeze frame data and fuel trim values. If the battery voltage falls below a minimum level, these memories are cleared and the TCM determines that there is a malfunction in the power supply circuit. When the engine is next started, the TCM will illuminate the MIL and set the DTC.
DTC No.
DTC Detection Condition
Trouble Area
P0560
Open in TCM back-up power source circuit.
DTC is detected for 3 sec. or more (1-trip detection logic).
  1. Open in TCM back-up power source circuit
  2. TCM

HINT:
If DTC P0560 is set, the TCM does not store other DTCs.


WIRING DIAGRAM

A122745E03

INSPECTION PROCEDURE


1. INSPECT TERMINAL VOLTAGE (BATT VOLTAGE OF TCM)

  1. C133210E25
    Disconnect the TCM connector.

  1. Turn the ignition switch on (IG).

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Specified Condition
    BATT (C56-1) - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (EFI NO. 1 FUSE - TCM)
OK


2. CHECK HARNESS AND CONNECTOR (TCM - BODY GROUND)

  1. C133210E20
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    E1 (C56-8) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TCM


← P0500 Vehicle Speed Sensor "A" (from Oct 2006)P0617 Starter Relay Circuit High (Oct 2006 – May 2009) →