TERMINALS OF ECU
System information · Vehicles built from Oct 2006
| CHECK MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK) |


Disconnect the E6, E7, IO, IK, IM, ID, IF and E9 J/B and ECU connectors.
Measure the voltage and resistance according to the value(s) in the table below.
Symbols (Terminal No.)
Wiring Color
Terminal Description
Condition
Specified Condition
DCTY (E7-24) - Body ground
L*1 - Body ground
Driver door courtesy switch input
Driver door CLOSED → OPEN
10 kΩ or higher → Below 1 Ω
Y*2 - Body ground
RCTY (E6-5)*3 - Body ground
GR - Body ground
Rear right door courtesy switch input
Rear right door CLOSED → OPEN
10 kΩ or higher → Below 1 Ω
RCTY (E6-7)*4 - Body ground
PCTY (E6-21) - Body ground
Y*1 - Body ground
Passenger door courtesy switch input
Passenger door CLOSED → OPEN
10 kΩ or higher → Below 1 Ω
L*2 - Body ground
LCTY (IO-7) - Body ground
LG - Body ground
Rear left door courtesy switch input
Rear left door CLOSED → OPEN
10 kΩ or higher → Below 1 Ω
GND2 (IM-9) - Body ground
W-B - Body ground
Ground
Always
Below 1 Ω
GND1 (IF-10) - Body ground
W-B - Body ground
Ground
Always
Below 1 Ω
L1*1 (IK-15) - Body ground
V*1 - Body ground
Driver door control switch LOCK input
Driver door control switch OFF → LOCK
10 kΩ or higher → Below 1 Ω
L1*2 (IJ-3) - Body ground
L*2 - Body ground
UL1*1 (IJ-4) - Body ground
G - Body ground
Driver door control switch UNLOCK input
Driver door control switch OFF → UNLOCK
10 kΩ or higher → Below 1 Ω
UL1*2 (IK-12) - Body ground
KSW*3 (E9-5) - Body ground
B - Body ground
Unlock warning switch signal input
No key is in ignition key cylinder → Key is in ignition key cylinder
10 kΩ or higher → Below 1 Ω
LGCY (E6-25) - Body ground
W - Body ground
Luggage compartment door courtesy switch input
Luggage compartment door CLOSED → OPEN
10 kΩ or higher → Below 1 Ω
TSW*2 (E6-2) - Body ground
R - Body ground
Luggage compartment door key-linked door unlock input
Using mechanical key, operate luggage compartment door lock cylinder to LOCK → OPEN → UNLOCK
10 kΩ or higher → Below 1 Ω → 10 kΩ or higher
BECU*3 (ID-10) - Body ground
O - Body ground
+B (BECU) power supply
Always
10 to 14 V
- HINT:
- *1: for LHD
- *2: for RHD
- *3: without Smart Entry and Start System
- *4: with Smart Entry and Start System
Reconnect the instrument panel J/B and main body ECU (instrument panel J/B) connectors.
Measure the voltage according to the value(s) in the table below.
Symbols (Terminal No.)
Wiring Color
Terminal Description
Condition
Specified Condition
IG (IF-11) - Body ground
B - Body ground
Engine power supply
Ignition switch on (IG) → off
10 to 14 V → Below 1 V
ACC (IF-2) - Body ground
B - Body ground
ACC power supply
Ignition switch on (IG) → off
10 to 14 V → Below 1 V
LSWL*4 (IP-5) - Body ground
GR - Body ground
Rear left door lock position switch input
Rear left door UNLOCK → LOCK
Below 1 V → 10 to 14 V (or pulse generation)
LSWP (E6-27) - Body ground
LG*1 - Body ground
Front passenger, rear left*3 or rear right*3 door lock position switch input
Rear right, rear left, or front passenger door UNLOCK → LOCK
Below 1 V → 10 to 14 V (or pulse generation)
L*2 - Body ground
LSWD (E7-9) - Body ground
L*1 - Body ground
Driver door lock position switch input
Driver door UNLOCK → LOCK
Below 1 V → 10 to 14 V (or pulse generation)
Y*2 - Body ground
UL2*1 (IK-7) - Body ground
GR*1 - Body ground
Driver door key-linked door unlock input
Using mechanical key, operate driver door lock cylinder LOCK → UNLOCK
Below 1 V → 10 to 14 V (or pulse generation)
UL3 (E7-10) - Body ground
GR - Body ground
Driver door key-linked door unlock input
Using mechanical key, operate driver door lock cylinder LOCK → UNLOCK
Below 1 V → 10 to 14 V (or pulse generation)
L2*1 (IK-16) - Body ground
BR*1 - Body ground
Driver door key-linked door lock input
Using mechanical key, operate driver door lock cylinder LOCK → UNLOCK
Below 1 V → 10 to 14 V (or pulse generation)
L2*2 (IJ-5) - Body ground
W*2 - Body ground
ACT+*1 (IK-2) - Body ground
W*1 - Body ground
Door lock motor LOCK drive output (Driver door)
Door control switch (Master switch) or driver side door key cylinder OFF → LOCK → OFF
Below 1 V → 10 to 14 V → Below 1 V
ACT+*2 (IJ-1) - Body ground
L*2 - Body ground
ACTD (E7-5) - Body ground
GR*1 - Body ground
Door lock motor UNLOCK drive output (Driver door)
Door control switch (Master switch) or driver side door key cylinder OFF → UNLOCK → OFF
Below 1 V → 10 to 14 V → Below 1 V
LG*2 - Body ground
ACT+*1 (IJ-1) - Body ground
L*1 - Body ground
Door lock motor LOCK drive output (Front passenger door)
Door control switch (Master switch) or driver side door key cylinder OFF → LOCK → OFF
Below 1 V → 10 to 14 V → Below 1 V
ACT+*2 (IK-2) - Body ground
W*2 - Body ground
ACT- (IJ-2) - Body ground
LG - Body ground
Door lock motor UNLOCK drive output (Front passenger door)
Door control switch (Master switch) or driver side door key cylinder OFF → LOCK → OFF
Below 1 V → 10 to 14 V → Below 1 V
ACT+ (IP-11) - Body ground
W - Body ground
Door lock motor LOCK drive output (Rear door LH)
Door control switch (Master switch) or driver side door key cylinder OFF → LOCK → OFF
Below 1 V → 10 to 14 V → Below 1 V
ACT- (IP-6) - Body ground
G - Body ground
Door lock motor UNLOCK drive output (Rear door LH)
Door control switch (Master switch) or driver side door key cylinder OFF → LOCK → OFF
Below 1 V → 10 to 14 V → Below 1 V
ACT+ (IF-5) - Body ground
L - Body ground
Door lock motor LOCK drive output (Rear door RH)
Door control switch (Master switch) or driver side door key cylinder OFF → LOCK → OFF
Below 1 V → 10 to 14 V → Below 1 V
ACT- (IF-18) - Body ground
B - Body ground
Door lock motor UNLOCK drive output (Rear door RH)
Door control switch (Master switch) or driver side door key cylinder OFF → LOCK → OFF
Below 1 V → 10 to 14 V → Below 1 V
TR+ (E7-1) - Body ground
B - Body ground
Door lock motor UNLOCK drive output (Luggage compartment door)
Luggage compartment open switch (Transmitter) or luggage compartment door key cylinder OFF → UNLOCK → OFF
Below 1 V → 10 to 14 V → Below 1 V
LSWR*4 (E6-5) - Body ground
V - Body ground
Rear right door lock position switch input
Rear right door UNLOCK → LOCK
Below 1 V → 10 to 14 V (or pulse generation)
- HINT:
- *1: for LHD
- *2: for RHD
- *3: without Smart Entry and Start System for RHD
- *4: with Smart Entry and Start System for RHD