2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Headlight Signal Circuit

Circuit diagnosis · Vehicles built Oct 2006 – May 2009

DESCRIPTION

The headlight leveling ECU receives the low beam headlights ON signal from the main body ECU.

WIRING DIAGRAM

E133295E02

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL J/B - HEADLIGHT LEVELING ECU)

  1. E121520E02
    Disconnect the ID instrument panel J/B assembly connector.

  1. Disconnect the A20 headlight leveling ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A20-3 (B2) - ID-3 (HRLY)
    Always
    Below 1 Ω
    A20-3 (B2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Light Control Switch Circuit (from Oct 2006)Door Courtesy Switch Circuit (from Oct 2006) →