REMOVAL
Removal / installation · Vehicles built Jun 2006 – Sep 2006
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
| 1.
PRECAUTION |
 |
- CAUTION:
- Be sure to read "PRECAUTION" thoroughly before servicing.
- HINT:
-
Click here
| 2.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.
| 3.
PLACE FRONT WHEELS FACING STRAIGHT AHEAD |
|
| 4.
REMOVE NO. 3 LOWER STEERING WHEEL COVER
|
 |
Using a screwdriver, disengage the claw and remove the No. 3 lower steering wheel cover.


- HINT:
- Tape up the screwdriver tip before use.
| 5.
REMOVE NO. 2 LOWER STEERING WHEEL COVER
|
 |
Using a screwdriver, disengage the claw and remove the No. 2 lower steering wheel cover.


- HINT:
- Tape up the screwdriver tip before use.
| 6.
REMOVE STEERING PAD
|
 |
Using a "TORX" socket (T30), loosen the 2 "TORX" screws until the groove along the screw circumference catches on the screw case.


- Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand.
- NOTICE:
- When removing the steering pad, do not pull the airbag wire harness.
Disconnect the horn connector from the steering pad.
Disconnect the 2 airbag connectors and remove the steering pad.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
| 7.
REMOVE STEERING WHEEL ASSEMBLY
|
 |
Remove the steering wheel assembly set nut.
Put matchmarks on the steering wheel assembly and the steering main shaft.
Disconnect the connectors from the spiral cable.
- Using SST, remove the steering wheel assembly.
- SST
- 09950-50013
(09951-05010, 09952-05010, 09953-05020, 09954-05031)
| 8.
REMOVE LOWER STEERING COLUMN COVER
|
 |
- Remove the 2 screws.
Disengage the 2 claws to remove the lower steering column cover.
| 9.
REMOVE UPPER STEERING COLUMN COVER
|
 |
- Disengage the claw to remove the upper steering column cover.
| 10.
REMOVE SPIRAL CABLE (w/o VSC) |
 |
- Disconnect the connectors from the spiral cable.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
Disengage the 3 claws and remove the spiral cable.
| 11.
REMOVE SPIRAL CABLE WITH STEERING ANGLE SENSOR (w/ VSC) |
 |
- Disconnect the connectors from the spiral cable with steering angle sensor.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
Disengage the 3 claws and remove the spiral cable with steering angle sensor.
| 12.
REMOVE SPIRAL CABLE (w/ VSC) |
 |
- Disengage the 6 claws and 2 pins, and remove the spiral cable from the steering angle sensor.