TERMINALS OF ECU
System information · Vehicles built Jun 2006 – Sep 2006
Versions by build date: Jun 2006 – Sep 2006 from Oct 2006
| CHECK SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF CONTROL ECU) |
![]() ![]() |
Disconnect the Q12 ECU connector.
Measure the resistance and voltage according to the value(s) in the table below.
If the result is not as specified, there may be a malfunction on the wire harness side.Symbols (Terminal No.)
Wiring Color
Terminal Description
Condition
Specified Condition
B (Q12-1) - E (Q12-2)
B - W-B
+B power supply
Always
10 to 14 V
IG (Q12-5) - E (Q12-2)
Y - W-B
Ignition switch power supply
Ignition switch off
Below 1 V
IG (Q12-5) - E (Q12-2)
Y - W-B
Ignition switch power supply
Ignition switch ON
10 to 14 V
OPN (Q12-7) - E (Q12-2)
BR - W-B
Sliding roof motor open
OPEN switch OFF
10 kΩ or higher
OPN (Q12-7) - E (Q12-2)
BR - W-B
Sliding roof motor open
OPEN switch ON
Below 1 Ω
CLS (Q12-9) - E (Q12-2)
L - W-B
Sliding roof motor closed
CLOSE switch OFF
10 kΩ or higher
CLS (Q12-9) - E (Q12-2)
L - W-B
Sliding roof motor closed
CLOSE switch ON
Below 1 Ω
UP (Q12-10) - E (Q12-2)
W - W-B
Sliding roof motor up
UP switch OFF
10 kΩ or higher
UP (Q12-10) - E (Q12-2)
W - W-B
Sliding roof motor up
UP switch ON
Below 1 Ω
DWN (Q12-8) - E (Q12-2)
G - W-B
Sliding roof motor down
DOWN switch OFF
10 kΩ or higher
DWN (Q12-8) - E (Q12-2)
G - W-B
Sliding roof motor down
DOWN switch ON
Below 1 Ω
E (Q12-2) - Body ground
W-B - Body ground
Ground
Always
Below 1 Ω
Reconnect the Q12 ECU connector.
Measure the voltage according to the value(s) in the table below.
If the result is not as specified, the ECU may have a malfunction.Symbols (Terminal No.)
Wiring Color
Terminal Description
Condition
Specified Condition
OPN (Q12-7) - E (Q12-2)
BR - W-B
Sliding roof motor open
Ignition switch ON, sliding roof closed, OPEN switch OFF
Below 1 V
OPN (Q12-7) - E (Q12-2)
BR - W-B
Sliding roof motor open
Ignition switch ON, sliding roof closed, OPEN switch ON
10 to 14 V
CLS (Q12-9) - E (Q12-2)
L - W-B
Sliding roof motor closed
Ignition switch ON, sliding roof open, CLOSE switch OFF
Below 1 V
CLS (Q12-9) - E (Q12-2)
L - W-B
Sliding roof motor closed
Ignition switch ON, sliding roof open, CLOSE switch ON
10 to 14 V
UP (Q12-10) - E (Q12-2)
W - W-B
Sliding roof motor up
Ignition switch ON, sliding roof tilted downward, UP switch OFF
Below 1 V
UP (Q12-10) - E (Q12-2)
W - W-B
Sliding roof motor up
Ignition switch ON, sliding roof tilted downward, UP switch ON
10 to 14 V
DWN (Q12-8) - E (Q12-2)
G - W-B
Sliding roof motor down
Ignition switch ON, sliding roof tilted upward, DOWN switch OFF
Below 1 V
DWN (Q12-8) - E (Q12-2)
G - W-B
Sliding roof motor down
Ignition switch ON, sliding roof tilted upward, DOWN switch ON
10 to 14 V

